• Obecnie brak na stanie
Pololu 1635 - Passive Infrared (PIR) Detector SE-10
search
  • Pololu 1635 - Passive Infrared (PIR) Detector SE-10
ID: 196160

Passive Infrared (PIR) Detector SE-10

Wycofany
 

Wysyłka gratis

darmowa wysyłka na terenie Polski dla wszystkich zamówień powyżej 500 PLN

 

Wysyłka tego samego dnia

Jeśli Twoja wpłata zostanie zaksięgowana na naszym koncie do godz. 11:00

 

14 dni na zwrot

Każdy konsument może zwrócić zakupiony towar w ciągu 14 dni bez zbędnych pytań

***Nowszą wersję tego czujnika znajdziesz pod nazwą SEN-13285

Kliknij, aby przejść do produktu***

Passive Infrared (PIR) Detector SE-10

The passive infrared detector (PID) motion sensor SE-10, also called a passive infrared (PIR) sensor, detects movement of infrared light sources at 7 to 14 µm. People emit infrared radiation from 8 to 14 µm, which makes this an excellent sensor for detecting human movement. Two infrared detector “pixels” allow the detector to filter out changes affecting the whole sensing area, like weather or light.

PIR motion sensor SE-10 top view.

Overview

The SE-10 passive infrared detector senses motion of infrared light sources at the same wavelengths humans emit. Passive infrared detectors like the SE-10 are used in security and automation applications. In security, motion sensors are integrated into alarm systems and used to turn on security cameras. PIR motion detectors are also used to automatically turn on lights when people enter a room.

The two pyroelectric sensing elements allow the SE-10 IR motion detector to see moving infrared light sources while ignoring changes in background infrared radiation. A lens focuses the infrared light on to the two 2?1 mm silicon coated sensing elements spaced 1 mm apart.

When the sensor is powered on, it takes 1-2 seconds to calibrate itself to the background infrared radiation before it can detect motion. After calibration, the detector drives the open-collector Alarm pin low for the duration of the sensed motion (the alarm pin state is not latched); when there is no motion detected, the alarm pin is floating. The open-collector setup allows multiple motion sensors to be connected on a single input pin, but it means that you will need an external pull-up resistor on the alarm pin. If any of the motion sensors go off, the input pin will be pulled low.

Connections

The red wire is power (5 to 12V), brown wire is GND, and black wire is an open-collector signal (Alarm) that requires an external pull-up. This sensor works from 5 to 12 V (datasheet shows 12 V). You can also install a jumper wire past the 5 V regulator on board to make this unit work at 3.3 V. The sensor draws 1.6 mA at 3.3 V.

The connector is slightly odd but has a 0.1" pitch female connector making it compatible with jumper wires and 0.1" male headers.

People often buy this product together with:

Pololu Carrier with Sharp GP2Y0D810Z0F Digital Distance Sensor 10cm Pololu Carrier with Sharp GP2Y0D810Z0F Digital Distance Sensor 10cm
Mini Pushbutton Switch: PCB-Mount, 2-Pin, SPST, 50mA (5-Pack) Mini Pushbutton Switch: PCB-Mount, 2-Pin, SPST, 50mA (5-Pack)
'0.1" 0.1" (2.54mm) Crimp Connector Housing: 1x3-Pin 25-Pack
196160

Produkty z tej samej kategorii (16)