Kit containing Raspberry Pi Pico and Raspberry Pi 4B 4 GB. The kit also...
Module with the RP2040 microcontroller with two ARM Cortex-M0 + cores...
Kit containing Raspberry Pi Pico and Raspberry Pi 4B 4 GB. The kit also...
Kit containing Raspberry Pi Pico and Raspberry Pi 4B 4 GB. The kit also...
Kit containing Raspberry Pi Pico and Raspberry Pi 4B 4 GB. The kit also...
Starter kit containing Raspberry Pi Pico, necessary connectors and a...
Module with a gas concentration sensor MQ2, which enables the detection...
Module with relay up to 5.5 A and 240 V AC controlled by the I2C interface. SparkFun COM-15093
Module with four relays designed for Raspberry Pi minicomputers. Equipped with relays that allow switching current up to 15 A. The module is controlled via the I2C interface. Seeed Studio 103030029
Module with SSR 240V/2A relay controlled by 5V voltage with fuse. modSSR-1CH
Your 5V system can wield great power with this big, beefy relay board. Kit contains all the parts you need to get your high-power load under control. Sparkfun KIT-13815
12V relay module with a radio receiver in a set with a remote control operating at 433 MHz.
Programmable time module with relay, allows you to set the time and manner of relay reaction on the trigger signal, has a built-in LED display. It can be supplied with voltage from the range of 6 - 30VDC or using the microUSB connector
The module contains two 5V relays with a maximum current of 10A (250 VAC) and opto-isolated inputs, and with jumpers it is possible to select switching with high or low status. The module is equipped with screw connectors. modRL02_ISO
The module contains four 5V relays with a maximum current of 10A (250 VAC) and opto-isolated inputs, and with jumpers it is possible to select switching with high or low status. The module is equipped with screw connectors. modRL04_ISO
The module is equipped with four 10A / 250VAC relays controlled independently via a serial bus (UART) or from a PC (through a microUSB connector). The NO / NC contacts of the relays have been led to the ARK screw terminals. ICSTATION ICSE012A
The module contains eight 5V relays with a maximum current of 10A (250 VAC) and opto-isolated inputs, and with jumpers it is possible to select high or low switching. The module is equipped with screw connectors. modRL08_ISO