USB to TTL Serial Cable - Debug / Console Cable for Raspberry Pi
search
  • USB to TTL Serial Cable - Debug / Console Cable for Raspberry Pi
ID: 563560
zł60.59
Tax included

zł49.26 tax excl.

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets. Adafruit 954

24h
Available
Available quantity: 2
 

Free shipping

free shipping in Poland for all orders over 500 PLN

 

Same day shipping

If your payment will be credited to our account by 11:00

 

14 days for return

Each consumer can return the purchased goods within 14 days

Description

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.

Because of the separated pin plugs, this cable is ideal for powering and connecting up to the debug/login console on the Raspberry Pi or BeagleBone Black. Connect the pins as shown to power the Pi or BBB and establish the RX/TX link.

  • If you are running Windows 7/8/10 etc, check the tutorial with links to drivers for both PL2303 and CP2102
    - see "TUTORIAL Software Installation (Windows)" down below at Download
  • If you are running Mac OS X, check the tutorial with links to drivers for both PL2303 and CP2012
    - see "TUTORIAL Software Installation (Mac)" down below at Download
  • If you are running Linux, drivers are already included in the kernel, no need to install anything!

Also handy for hacking WiFi routers to install alternate OS's, or nearly any other 3.3V logic serial port. This is easier to use than an FTDI cable in many cases because the wires are separated. Note that we call this a "TTL cable" (since that's what they're called) but technically it's CMOS logic.

This cable is not good for Arduino re-programming such as a Boarduino, MENTA, Monochron, etc. because it does not have the DTR/RTS wire necessary for initiating the bootloader reboot sequence. For that we suggest an FTDI cable or FTDI friend.

Features

There are four wires:

  • red power
  • black ground
  • white RX into USB port
  • green TX out of the USB port

The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.

563560

You might also like

Other products in the same category (16)