- Out-of-Stock
Rover 5 Robot Platform
ID: 201310
ROB-10336
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
If you’re looking for a chassis base for your next robot, look no further than the Rover 5. The Rover 5 uses 4 independent motors, each with a hall-effect quadrature encoder and gearbox. The entire gearbox assembly can be rotated at 5 degree increments for different clearance configurations. You can even replace the tank treads with traditional wheels.
This isn’t a wimpy or flimsy robot base. Weighing in at over 2.5 pounds without batteries, this base is heavy duty and can drive over quite a bit. Check the manual below for dimensional drawings.
Features
- Adjustable gear box angles
- 4 independent DC motors
- 4 independent hall-effect encoders
- Thick rubber tank treads
- 6x AA battery holder
- 10Kg/cm stall torque per motor
Documents
201310
You might also like
Dagu Rover 5 Tracked Chassis
zł285.69
24h
Available quantity: 1
Available
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
zł113.90
24h
Available quantity: 70
Available
This is a breakout board for ON Semiconductor’s AMIS-30543 microstepping bipolar stepper motor driver, which features SPI-adjustable current limiting, 11 step modes (from full-step through 1/128-step), back-EMF feedback that can be used for stall detection or optional closed-loop control, and over-current and over-temperature protection.
zł86.70
24h
Available quantity: 3
Available
This breakout board for TI’s DRV8880 microstepping bipolar stepper motor driver features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (down to 1/16-step).
Delivery date unknown
No product available!
Other products in the same category (16)
Laurens Valk
Delivery date unknown
No product available!
Motion MEMS and environmental sensor expansion board for STM32 Nucleo, equipped with Arduino UNO R3 connector layout; designed around the LSM6DSL 3D accelerometer and 3D gyroscope, the LSM303AGR 3D accelerometer and 3D magnetometer, the HTS221 humidity and temperature sensor and the LPS22HB pressure sensor. The board interfaces with the STM32 microcontroller via the I²C pin
Retired
No product available!
Measuring recorder 8 inputs, lcd display, serial connection - set for self-assembly
Retired
No product available!
No product available!
LPCXpresso55S16 evaluation kit with LPC55S16 microcontroller with ARM Cortex-M33 core. The board contains built-in LPC-Link2, audio subsystem, accelerometer, USB interfaces and Arduino connectors. NXP LPC55S16-EVK
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Printed circuit board and programmed layout for a miniature reminder. AVT5638 A +
Retired
No product available!
No product available!
No product available!
The module with the NEO-M8N GPS system and an external antenna designed for the M5Stack sets. M5Stack M031-G
Retired
No product available!
No product available!
ROB-10336