Order and pay in
for same day shipping
Module with 4 relays controlled by the I2C interface. Each relay can...
USB port isolator based on the ADUM3160 chip with 4 output ports. The...
HDMI/DisplayPort cable, 1.8 m long. Akyga AK-AV-05
5 MP camera with OV5640 sensor and 180° wide-angle lens. OV5640-A28
Microscope lens with adjustable zoom up to 130 times. Can be connected...
USB port isolator with magnetic isolation. The device has a rated...
Virtual keyboard module in the form of a small flash drive. It allows...
Development board with ST Zio and ST morpho connectors, based on the...
Adafruit 1651, 2.8" TFT Touch Shield for Arduino v2
Spice up your Arduino project with a beautiful large touchscreen display shield with built in microSD card connection. This TFT display is big (2.8" diagonal) bright (4 white-LED backlight) and colorful (18-bit 262,000 different shades)! 240x320 pixels with individual pixel control. It has way more resolution than a black and white 128x64 display. As a bonus, this display has a resistive touchscreen attached to it already, so you can detect finger presses anywhere on the screen.
Weve updated our original v1 shield to an SPI display - its a tiny bit slower but uses a lot less pins and is now much easier to use with Mega & Leonardo. We also include an SPI touchscreen controller so you only need one additional pin to add a high quality touchscreen controller. Even with all the extras, the price is lower thanks to our parts sourcing & engineering skillz!
The shield is fully assembled, tested and ready to go. No wiring, no soldering! Simply plug it in and load up our library - youll have it running in under 10 minutes! Works best with any classic Arduino (UNO/Duemilanove/Diecimila). Solder three jumpers and you can use it at full speed on a Leonardo or Mega as well.
This display shield has a controller built into it with RAM buffering, so that almost no work is done by the microcontroller. This shield needs fewer pins than our v1 shield, so you can connect more sensors, buttons and LEDs: 5 SPI pins for the display, another pin for the SPI touchscreen controller and another pin for uSD card if you want to read images off of it.