Adafruit DragonTail adapter with connector for micro:bit

1.8inch LCD for micro:bit is an overlay with LCD display. The screen has a resolution of 160x128 pixels. The module has a standard micro: bit interface. 1.8inch LCD for micro: bit

Edge Breakout for micro: bit is an expansion board for the micro: bit module. It offers leaded I / O pins on a 3 x 25 pin gold pin connector. There are available anlog entries, GPIO pins, I2C and SPI interfaces, as well as power pins. Edge Breakout for micro: bit

A set for building an interactive teddy bear-shaped pendant based on a micro:bit. It consists of a micro:bit v2 educational module, a scroll:bit module with a matrix display, a lanyard and a battery. Pimoroni PIM362

The expansion module is designed for micro:bit sets. Offers a simple, beginner-friendly robotics controller. SparkFun DEV-15713

A module with an electret microphone, amplifier and ADC converter dedicated to micro: bit. It communicates via the I2C interface. SparkFun SEN-15289

Starter kit with micro:bit v2. In addition to the micro:bit v2 board, the set includes a microUSB-USB cable, a battery basket and two AAA batteries. SparkFun DEV-17288

The SparkFun micro:bit Breakout is a board that connects to the BBC micro:bit and expands the capabilities of the development platform by providing access to more pins and allowing for connections to the I²C and SPI buses. This breakout board for the micro:bit’s edge connector allows to connect the micro:bit to breadboards and other sensors, motors, LEDs and more! BOB-13988

An accessory from the gator:boards series. The board has large pads dedicated for crocodile-type wires for easy connection to the micro:bit. It includes a temperature sensor module (MCP9700), a light sensor (TEMT6000) and an RGB LED board. SparkFun SEN-14891

Soil moisture sensor dedicated to micro:bit. It is supplied with the voltage from 3.3 V to 5 V and communicates via an analog signal. SparkFun SEN-15272

SparkFun micro:bot kit v2.0 - is the perfect controller for learning how to build and program robots. The combination of micro:bit with the SparkFun moto:bot carrier board creates an efficient, cheap robotics platform with Qwiic support for robot enthusiasts of all ages. With SparkFun micro:bot, you can quickly create simple robots. SparkFun kit-16275

DEV-14213

The module with six touch buttons and LED diodes is designed for micro:bit. It uses the CAP1166 driver and communicates via the I2C interface. Pimoroni PIM401

Module with the real time clock (RTC) RV-3028 dedicated to micro:bit. It communicates via the I2C interface. SparkFun SEN-15486

The IO expansion module is designed to work with the micro:bit educational board. There are 20 GPIO pins on the board, a buzzer and a voltage stabilization circuit

Expansion module compatible with micro:bit. The board is equipped with a 24 V 2 A relay, two buffer inputs, two sink outputs and three analog inputs with a working range up to 24 V. Pimoroni PIM371

The module with a heart rate sensor and the SpO2 level dedicated to micro:bit. It is based on the MAX30102 chip and communicates via the I2C interface. SparkFun SEN-15271