Categories

Kamami.pl - Official Raspberry Pi distributor

New products



GPS-RTK Dead Reckoning Breakout- GPS module with the ZED-F9R

GPS module with u-blox ZED-F9R. Uses Automotive Dead Reckoning (ADR) technology. Provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-16344

More details

ID: 580588

344,60€ gross (23% VAT)
280,16€ net

Add to wishlist

More info

Description

GPS module with u-blox ZED-F9R. The module uses Automotive Dead Reckoning (ADR) technology. Provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. The ZED-F9R module can receive signals from the GPS, GLONASS, Galileo and BeiDou constellations with an accuracy of 0.2 meters (supports simultaneous reception of four GNSS systems). The module provides position accuracy in cities or in covered areas. Continuous positioning is ensured even under weak signal conditions and is available in the event of total signal loss (e.g. short tunnels and garages). The ZED-F9R is an excellent solution for autonomous robots that require accurate positioning in difficult conditions.

Attention!
For proper operation, the module requires a GPS antenna, which is not included in the set. It must be purchased separately.

The board also has two Qwiic connectors and a USB Type-C connector for communication with the system.

Features

  • 2 x Qwiic connector
  • Integrated U.FL antenna connector
  • Compatible with GPS, GLONASS, Galileo and BeiDou
  • 184-channel GNSS receiver
  • Receives the bands L1C / A and L2C
  • Position accuracy: 0.20 m with RTK
  • Maximum navigation speed: up to 30 Hz
  • Acquiring position:
    • Cold start: 24 sec
    • Hot start: 2 sec
  • Operation limitations:
    • Max G: ≤4G
    • Maximum altitude: 50 km
    • Maximum speed: 500 m / s
  • Speed accuracy: 0.5 m / s
  • Course accuracy: 0.2 degrees
  • Built-in accelerometer and gyroscope
  • Timing Pulse Accuracy: 30 ns
  • Configurable software:
    • Geofencing
    • Odometer
    • External interrupt
    • Pin control
    • Low power consumption mode
  • Supports NMEA, UBX and RTCM protocols over UART
  • Voltage: 5V or 3.3V
  • Current: 85 mA to 130 mA

Downloads

Manufacturer

Accessories