Module with a gas concentration sensor MQ2, which enables the detection...
Module with vibration sensor LDT0-028. The board is equipped with a...
Module with the MQ3 alcohol concentration sensor. The board is equipped...
A module with an NFC PN532 transceiver, which supports proximity...
Silicone case designed for the micro:bit educational...
Silicone case designed for the micro:bit educational module. Yellow...
A set for building a smartwatch based on the micro:bit educational...
Starter kit for the micro:bit educational module. The kit includes an...
ID: 208507
Availability date:
The ELF-VLF receiver, or rather a set of receivers, enables reception of mysterious radio signals with extremely low frequencies. It is possible to observe signals of communication with submarines and so-called Schumann resonance.
It is possible only in extra-urban conditions (eg during trips), and this is due to the high level of industrial disturbance in cities. In the city, the described systems can be used, for example, to observe storms and the level of industrial disturbances. Such their use can also be very interesting. A lot of information about the reception of electromagnetic waves at very low frequencies, below 30kHz, as well as about antennas used for this type of receivers, is provided in the article 'Receiving ELF-VLF radio waves'.
The project presents four receivers, designed to receive radio signals (electromagnetic waves) in the range from 3Hz to 30kHz, thus including bands: ELF, SLF, ULF and VLF. The first of the receivers (I) cooperates with a wire antenna, reacting to the electrical component of the electromagnetic field. It was made in two system versions (Ia and Ib). The third and fourth are designed to cooperate with a loop antenna, reacting to the magnetic component of the electromagnetic field. The article also describes the system generating symmetrical power supply voltage and systems improving work comfort by increasing resistance to unwanted signals: two low-pass filters with band respectively 200Hz and 20kHz, bandpass filter, reducing the hum of 50Hz and optoisolator m signals .cz. The described systems do not require tuning or startup, so that even a novice electronics can do it. The big advantage of these systems is the low cost of their implementation.
Note: the project has been divided into 6 parts:
AVT3054 / 4
The receivers (AVT3054 / 1, AVT3054 / 2, AVT3054 / 3) should be supplied with symmetric voltage from a pair of batteries or accumulators or by means of an 'artificial mass' generating system. The use of such a symmetrical power supply significantly simplifies the construction of the systems. If you need to use a power supply other than battery or battery power, you should carefully choose the system solution. It should be remembered that all switched-mode power supplies and DC / DC converters are sources of voltage disturbances that are too strong to be used directly.
Includes AVT3054 / 4 printed circuit board and documentation.
Detailed description in EdW3 / 13 or
Additional materials:
Article 'ELF-VLF radio reception' from the journal Elektronika Dla Wszystkich 10/2011