Voltage Regulator module 7.5V Step-Down 2.6A D36V28F7
ID: 586590
zł90.97
Tax included
zł73.96 tax excl.
Step-Down converter D36V28F7 with an output voltage of 7.5 V, an input voltage from 8 to 50 V and a maximum output current of 3.7 A. Pololu 3784
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
Step-Down converter module D36V28F7 with an output voltage of 7.5 V and an input voltage from 8 to 50 V. The maximum current load of the module is from 2 to 3.7 A and depends on the input voltage. The inverter achieves a standard efficiency of over 80-90%, which is dependent on the input voltage and load. The module is protected against reverse polarity, overheating, overload and short circuit.
Pinout
- VIN - power input
- GND - ground
- VOUT - output
- PG - an open drain output that goes low when the regulator's output voltage rises more than 20% above or drops by more than 10% below the nominal voltage
- EN - converter is enabled by default (100 kΩ pull-up resistor on the board connects EN pin with VIN). The ENABLE pin can be set low to turn off the power and put the board into a low-power state.
Features
- Input voltage: 8 to 50V
- Output voltage: 7.5V
- Type. maximum current: from 2 to 3.7 A
- Built-in protection against overheating, overload, short circuit and reverse polarity
- Type. efficiency: 80-90%
- Switching frequency: approx. 500 kHz under heavy loads
- Energy saving mode
- Typical quiescent current from 2 mA to 3 mA
- EN input with a precise cut-off threshold to disconnect the load and put the controller into a low-power state
- Power good output, which indicates when the controller cannot maintain the output voltage adequately
- The soft-start function limits the inrush current and gradually increases the output voltage
- Two M2 mounting holes
- Dimensions: 17.8 x 20.3 x 8.8 mm
Parameters
Kit contains
- D36V28F7 converter module
- Straight 6-pin goldpin connector
- 5-pin angled goldpin connector
586590
Data sheet
- Output voltage
- 7,5 V
- Output current
- 2,6 V
- Converter type
- Step-down
- Supply voltage min
- 8 V
- Supply voltages max
- 50 V
You might also like
The Step-Up Buck Voltage Regulator module with adjustable output voltage in range of 4-25V with a input voltage range of 1.5-16V and a maximum output current of 2A. Pololu 799
zł70.86
24h
Available quantity: 3
Available
Step-Up converter U3V70A with an output voltage from 4.5 to 20 V, an input voltage from 2.9 to VOUT and a maximum output current of 10 A. Pololu 2890
zł111.47
Delivery date unknown
No product available!
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output on a 5.08 mm ARK screw connector. Allows you to power devices with 5 V, 9 V, 12 V, 15 V and 20 V and test chargers by replacing the PD device
zł39.90
24h
Available quantity: 3
Available
A set of 40 pieces of female-female connecting cables in various colors, 10 cm long
zł4.90
24h
Available quantity: 1355
Available
A set of 40 pcs of male-female connecting cables in various colors, 10 cm long
zł4.34
24h
Available quantity: 68
Available
A set of 40 pcs of male-male connecting cables in various colors, 10 cm long
zł5.72
24h
Available quantity: 214
Available
Step-Down converter D36V50F7 with an output voltage of 7.5 V, an input voltage from 8.3 to 50 V and a maximum output current of 7 A. Pololu 4093
zł119.63
24h
Available quantity: 3
Available
Other products in the same category (16)
Step-Down XL4005 converter module with adjustable output voltage in the range from 0.8 to 30 V with a wide input voltage range from 4.5 to 30 V and a maximum output current of 5 A
zł19.40
24h
Available quantity: 21
Available
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 36V and efficiently reduces it to 5V. The board measures only 0.7″ × 0.7″ yet delivers a typical continuous output current of up to 2.5A and features reverse voltage protection. Pololu 2858
zł53.14
24h
Available quantity: 2
Available
The Step-Down D24V6AHV Buck Voltage Regulator module with adjustable output voltage in the range of 4-25V with a wide input voltage range of 4.5-42V and a maximum output current of 600 mA. Pololu 2104
zł40.28
24h
Available quantity: 2
Available
Step-Down RT8272 converter with adjustable output voltage in the range from 5 V to 12 V, input voltage from 5 to 24 V and a maximum output current of 3 A
zł10.33
24h
Available quantity: 19
Available
DFR0379
zł25.90
24h
Available quantity: 6
Available
Step-Down converter with adjustable output voltage from 1.25 to 36 V, input voltage from 4 to 38 V and maximum current up to 5 A
zł7.68
24h
Available quantity: 75
Available
Step-Down DC-DC converter module based on the D36V6F3 system. Input voltage 4 ... 50V, output voltage 3.3V (max. 600mA). Polol 3791
zł35.14
24h
Available quantity: 1
Available
Step-Down converter with an output voltage of 5 V, an input voltage of 6.5 to 16 V and a maximum current of 4 A
zł13.37
24h
Available quantity: 17
Available
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 3.3 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 80% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.
zł94.96
6 weeks
No product available!
Step-Down converter D36V28F5 with an output voltage of 5 V, an input voltage from 5.3 to 50 V and a maximum output current of 4 A. Pololu 3782
zł81.44
6 weeks
No product available!
No product available!
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 6 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.
zł83.22
6 weeks
No product available!
DC-DC Step-Down converter module AP63203 with an output voltage of 3.3 V, an input voltage of 3.8 to 32 V and a maximum output current of 2 A. SparkFun COM-18357
zł23.92
24h
Available quantity: 6
Available
No product available!
Step-Down DC-DC converter module based on the D36V6F12 system. Input voltage 12.2.50V, output voltage 12V (max. 600mA). Pololu 3796
zł34.82
24h
Available quantity: 4
Available
Step-Down converter D36V50F5 with an output voltage of 5 V, an input voltage from 5.5 to 50 V and a maximum output current of 8 A. Pololu 4091
zł120.96
24h
Available quantity: 2
Available
Step-Down converter D36V28F7 with an output voltage of 7.5 V, an input voltage from 8 to 50 V and a maximum output current of 3.7 A. Pololu 3784