ESP8266 WiFi NodeMcu Shield - motherboard with engine controller for NodeMCU
ID: 561433
zł7.87
Tax included
zł6.40 tax excl.
The base board for the Wi-Fi NodeMCU module (ESP-12E), thanks to the built-in L293DD system, allows for attaching e.g. motors, electromagnets or other executive devices. The I/O lines of the NodeMCU module were derived to the pin connectors, and the power supply can be connected with the use of screw connectors. ESP12E Motor Shield
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
The base board for the Wi-Fi NodeMCU module (ESP-12E), thanks to the built-in L293DD system, allows for attaching eg motors, solenoids or other executive devices. The I/O lines of the NodeMCU module were derived to the pin connectors, and the power supply can be connected with the use of screw connectors.
Features
- Cooperation with the NodeMCU Wi-Fi module
- The built-in L293DD controller allows the load to be connected (max. Current consumption: 600 mA)
- Engine power supply: 4.5V...36V
- Supply voltage of the NodeMCU module: 4.5V...9V
- Screw connections for powering the module, actuator and L293DD loads
- Built-in power switch
- The I/O lines of the NodeMCU module lead to pin connectors
- Mounting holes with a diameter of 3mm
- Tile dimensions: 58x43x13mm
561433
You might also like
WiFi module based on ESP8266. The module has a built-in antenna and USB-UART converter. The module can be programmed in Lua (under the control of the NodeMCU firmware) or in the Arduino environment. 10 GPIO lines are available which each can be configured to work as PWM, I2C.
zł32.69
24h
Available quantity: 16
Available
Other products in the same category (3)
Wi-Fi module based on the ESP8266 system - simplicity of use (communication through UART, supports AT commands), 3.3V power supply, support for WPA / WPA2 encryption - these features make the EPS8266 module applicable anywhere, where reliable and effective data transmission. The module is not equipped with an antenna, it should be attached using the U.FL connector. ESP-05
zł17.90
24h
Available quantity: 25
Available
WiFi 802.11 b/g/n module with ESP8266 system, 16 terminals are available with a 2 mm pitch with the possibility of soldering gold pins, there are 9 GPIO lines and 1 ADC line on the connector. Built-in ceramic antenna and U.FL antenna connector. ESP-07
zł11.89
24h
Available quantity: 64
Available
WiFI 802.11 b/g/n module. Equipment includes, among others: LED diode, antenna, 8 pins with 2.54mm pitch (including 3 GPIO lines). Power supply: 3.3V.
zł10.96
6 weeks
No product available!
The base board for the Wi-Fi NodeMCU module (ESP-12E), thanks to the built-in L293DD system, allows for attaching e.g. motors, electromagnets or other executive devices. The I/O lines of the NodeMCU module were derived to the pin connectors, and the power supply can be connected with the use of screw connectors. ESP12E Motor Shield