List of products by brand Inny

The OV5640 camera module is a 5-megapixel unit with a lens with a viewing angle of 110 degrees and a 24-pin connector. It is equipped with an IR Cut switch and a 70-mm cable, which allows it to automatically switch between day and night modes.

Module with four 240V/2A relays controlled by 5V with a fuse triggered by a high state. modSSR-4CH-H

Module with pulse and SpO2 level sensor (oxygen saturation level). The module is based on the MAX30102 chip and communicates via the I2C interface.

Module with eight 240V/2A relays controlled by 5V with a fuse triggered by a high state. modSSR-8CH-H

4-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end

Evaluation kit with WiFi/Bluetooth module BLE ESP32-WROOM-32U. The board is equipped with a USB-UART converter, which through the microUSB connector allows you to power and program the board. Espressif ESP32-DevKitC-32U

Light ring with 32 RGB LEDs, type WS2812, controlled by a serial signal. The module can be powered by 5V, only one signal line is required to control it.

Light ring with 40 RGB LEDs, type WS2812, controlled by a serial signal. The module can be powered by 5V, only one signal line is required to control it.

Light ring with 60 RGB LEDs, type WS2812, controlled by a serial signal. The module can be powered by 5V, only one signal line is required to control it.

10-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end

3.7V li-ion battery charger based on TP4056 chip equipped with USB type C connector. HW-373

4-port USB 3.0 Hub with indicators and switches for each of the USB ports. It has the ability to connect an external power supply and use the device as an active hub. modHUB3_4_ACTIVE

Holder for attaching the glass to the 3D printer table in the form of a clamp clip

Large momentary button with a diameter of 100 mm with LED backlight. It was based on a limit switch. The housing is black

Six-part plastic case with fan for Raspberry Pi 4.

Open case with fan for Raspberry Pi 4 model B minicomputers.

Two-axis joystick with 5 kΩ resistance potentiometers that register the position of the X and Y axes. It provides precise motion control in two dimensions, allowing the user to smoothly control connected devices. JH-D202X-R2

4/8 position control stick with trigger. It has SANWA type leads so can be easily integrated into existing designs. Shooter Arcade Joystick

4/8 position control stick with trigger. It has ZIPPY type leads so can be easily integrated into existing designs. Shooter Arcade Joystick

Large momentary button with a diameter of 100 mm with LED backlight. It was based on a limit switch. The housing is black