List of products by brand Inny

Plastic holder for LEDs with a diameter of 5 mm. Set of 10 pieces

The module with a touch button can be used as a replacement for traditional mechanical buttons. It is based on the TTP223 chip, which measures the capacity of the field on the module

Module with a joystick with two analog axes (X and Y axis) with a button (Z axis). The board is equipped with an XH2.54 connector and has analog outputs

Waterproof LED indicator with a diameter of 8 mm, powered with the voltage from 9 to 12 V. White color

Waterproof LED indicator with a diameter of 8 mm, powered with the voltage from 9 to 12 V. Green color

A module with an electret microphone and an amplifier that will allow you to detect a voice, a clap or a door slam using the analog output

Trapezoidal screw, length 300 mm, diameter 8 mm and pitch 2 mm, supplied with a nut. Used for drives in 3D printers

Stepper motor driver that can work with a voltage in the range from 20 to 50 V and a maximum current of 5.6 A. It allows you to configure the microstep in the range from 2 to 128. DM556

A 20 cm long 3-pin cable with a JST XH2.5 female plug on one side

Stepper motor driver that can work with a voltage in the range from 20 to 50 V and a maximum current of 4.2 A. It allows you to configure the microstep in the range from 2 to 128. DM542

300 W lead and lead free soldering pot. It serves, among others for tinning/soldering of cable ends.

100 W lead and lead free soldering pot. It serves, among others for tinning/soldering of cable ends.

A 7-pin cable with a length of 30 cm, terminated on both sides with a Molex Picoblade 1.25 mm plug

10 cm 3-pin cable with JST PH2.0 female plug to 2.54 mm 3-pin female goldpin

A 20 cm long 6-pin cable with a JST XH2.5 female plug on one side

A 20 cm long 4-pin cable with a JST XH2.5 female plug on one side

10-pin connection cable with a length of 20 cm, terminated with a female goldpin plug and alligator connectors

Module with an active buzzer. The board is equipped with an XH2.54 connector and is controlled by a digital signal

10-pin connection cable with a length of 20 cm, terminated with a male goldpin plug and alligator connectors

The nozzle with a diameter of 1 mm for most heads used in 3D printers. Designed for 1.75 mm filaments