List of products by brand Inny

Blue USB 3.0 A cable - microUSB 3.0 B with 1m length, allowing SuperSpeed transmission (up to 5Gbit / s = 625MB / s)

A steel spacer, 30 mm long, with M4 thread

The ESD-11 straight tweezer is 140mm long. Anti-static, anti-magnetic, acid-resistant, hardness HRC40. The gripping part is coated. Perfect for work in SMD electronics

HLK-LD2410C is a 24 GHz radar sensor for human presence and micro-motion detection, featuring UART and BLE interface. modHLK-LD2410C

Permanent cylindrical neodymium magnet with a diameter of 20 mm and a height of 3 mm. Set of 5 pcs

The set contains 350 pcs of colored 22 AWG connecting wires of various lengths, designed to connect contact areas. WJW-60B

The module with an alcohol sensor (MQ-3), allows you to measure the concentration of ethanol in the air. The module has an analogue output and an output triggered by exceeding the threshold of sensitivity.

White plastic cap for a monostable button (Tact Switch). Fits 12x12x7.3 mm switches

EXTREME heat shrink tubing for electrical and mechanical insulation, diameter against shrinkage 8.0mm; diameter after shrinkage 4.0 mm, a set of 10 pieces with a length of 1 meter

Waterproof momentary button with a diameter of 12 mm and a height of 21 mm in a stainless steel housing. Yellow color

Module with an analog TEMT6000 light intensity sensor. The output voltage is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V

Adapter with 3.3V voltage regulator designed for NRF24L01 modules with 8-pin connector

Evaluation kit equipped with STM32F103C8T6 microcontroller (ARM Cortex M3, 72MHz, 64kB Flash, 20kB SRAM). It has two 20-pin connectors enabling the use of numerous microcontroller peripheral systems.

7-segment LED display, 1 digit 20.40mm, two dots, light yellow (592nm), 5000 ucd (10mA), common anode, Pb-free. LED1-AS-B-08012BMY

Bearing GT2 pulley for shaft diameter 5 mm. It has 20 teeth, suitable for a 6mm wide belt

Rectangular LED diode 5x2 mm RED milk diffused, angle 160 degrees; light intensity 30 mcd (20mA) (2.0V); df 635nm

A wireless transceiver operating in the 434 MHz band based on the RFM69HCW system. Maximum power: 100mW; bit rate up to 300kbps. Range in the open space reaches up to 500m. The module communicates using the SPI bus. Compatible with Arduino

Male terminal block, angled, 18-pin. Pitch 3.81mm. Height 7mm. 15EDGRC. Set of 5 pieces

8-core cable, 30 cm long, terminated on one side with a JST XH-2.5 female plug