List of products by brand Inny

A set of two probes for a digital multimeter and crocodile clips. Clips make easier to measure parameters on threaded elements and connectors.

The HT202B crimper is a tool for crimping insulated and uninsulated connectors of various types with a cutting function. NAR0012-2

ARK terminal connector spring 3-pin, pitch 5.00 mm, non-detachable. Set of 5 pieces

SMD connector, bottom contact, 34pin, pitch 0.5mm

The cable is terminated on one side with a male connector JST RCY (BEC)

LM35 analog temperature sensor module. It allows you to measure the temperature in the range from 0°C to 100°C with a resolution of 0.5°C

DisplayPort cable version 1.4 terminated on both sides with a plug. 2m length, black cable. Logilink CV0120

ETH01-EVO is an IoT communication module based on the ESP32-C3 microcontroller with support for 2.4 GHz WiFi, Bluetooth 5 LE and 10/100 Mb/s Ethernet via an RJ45 connector. It enables TCP/IP communication and control via AT commands, intended for integration with embedded systems. ETH01-EVO

ETH01-EVO-PoE is a dedicated Power over Ethernet supply module designed exclusively for use with the ETH01-EVO module. It enables powering the device directly via the Ethernet cable using PoE technology, eliminating the need for an additional power supply

Micro analog servo with plastic gear. It has a range of motion of 90°. GH-S43A

The nozzle with a diameter of 0.6 mm for most heads used in 3D printers. Designed for 1.75 mm filaments

The Step-Down panel-mounted converter module enables precise regulation of input voltage (6V-70V) and output current (0-5A), with a maximum output power of 300W, conversion efficiency up to 95%, and short-circuit and anti-reverse connection protection. The device, with dimensions of 120mm x 64mm x 72mm, is equipped with continuous regulation functions, with a resolution of 0.01V for voltage and 0.001A for current, and operates in a temperature range of -10 to +75 degrees Celsius.

Module with ozone detection sensor. It performs measurements up to 10 ppm with a resolution of 0.01 ppm. It has a UART output and an analog output. ZE25-O3

The module with the MAX30100 chip that monitors the oxygen content in the blood and the heart rate. It consists of two LED diodes, a photodetector, optimized optics and low noise analog signal processing. modMAX30100

OLED display 1.5 ", resolution 128x128 pixels, 3V SSD1327 SPI GRAY SCALE, work temp. From -40 to +70.

Single-channel audio amplifier up to 100 W.

The PZEM-031 energy consumption meter is a device for internal use with a large LCD display that measures voltage, current, active power and energy in the voltage range of 6.5-100V DC and current 0-20A. It comes with power alarm, data memory and backlight control functions, but does not include additional cables or accessories.

OLED display 128x64 1.54 "AA, 3V SPD0301 I2C SPI Parallel White, working temperature from -40 to +70 ext. 12V

Adapter form IDC10 1,27 mm used on laser dust sensor PMS7003 to 2,54 mm goldpin. It helps with connecting sensor to standard breadboard or development boards (Arduino, STM32 etc.). It can be connected to PMS7003 easily, as connector fit with sensor\'s outputs

Module with a knock-on sensor for measurement of methane, propane and carbon monoxide (MQ-9) concentrations. The module has an analogue output and an output triggered by exceeding the threshold of sensitivity.