List of products by brand Inny

ARK terminal connector spring 5-pin, pitch 3.5 mm, non-detachable.

ARK terminal connector spring 4-pin, pitch 3.5 mm, non-detachable.

ARK terminal connector spring 3-pin, pitch 3.5 mm, non-detachable.

4-pin ARK mounting strip, 2.54 mm pitch. 308-2.54-04P-14-00AH

Pin header, 40 pin, 2,54mm

Kit includes 6 spools of yellow, green, red, blue, black and white wires with silicone flexible insulation. The set also includes heat shrink tubing, cable ties, insulation stripper and insulation tape

A needle with a diameter of 0.2 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

A small magnet designed for mounting RGB matrix displays. It fits perfectly into the holes in the panels

Module with the Infineon Optiga SLB 9670 TPM 2.0 cryptographic chip. It uses the SPI interface for communication and is compatible with all versions of the Raspberry Pi. LetsTrust TPM

Aluminum tensometer beam, allowing weight measurement up to 2 kilograms. It has four wires. It is used in kitchen scales and portable scales

SATA III to USB 3.0 adapter. It allows you to connect a 2.5" HDD, 3.5" HDD or SSD to a computer via USB. Comes with a 12 V power supply

Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm audio jack

Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna, microphone, 3.5 mm audio jack and control buttons

MP3 player with support for microSD cards and USB memory. It can work as a separate device and play sounds from a card or pendrive

A needle with a diameter of 0.6 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

A needle with a diameter of 0.5 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

A needle with a diameter of 0.35 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

A needle with a diameter of 0.3 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

Brush for cleaning nozzles in 3D printers. Made of brass wire, it facilitates the maintenance and service of 3D printers

Ethernet network cable UTP Cat6 patchcord, 2 m long, black, with 2xRJ45 connectors