List of products by brand Inny

Small metal gear motor, 1000 RPM speed, 6V operating voltage. GA12-N20-0018

A stepper motor controller that can operate with a voltage range of 24 to 110 VDC or 18 to 80 VAC and a maximum current of up to 8.4 A. It allows micro step configuration in the range of 2 to 256. 2DM860H

Cable (adapter) from BNC connector to banana plug. Allows convenient connection of a device, e.g. to an oscilloscope

The IO expansion module is designed to work with the micro:bit educational board. There are 20 IO pins on the board, a buzzer, audio output and voltage stabilization circuit

20 cm long cable with XT60 plug and two banana plugs. It allows you to connect a battery with an XT60 socket to the charger

Flexible LED (LED filament) in white, length 300 mm

Universal service holder with magnetic clamps. It enables quick and stable installation of printed circuit boards of various shapes

Flexible LED (LED filament) in white, length 130 mm

Laser sensor module with a range of up to 50 m and an accuracy of 1 mm. Communication with the module takes place via the UART interface.

SOT23 to DIP adapter in the form of a PCB.

Flexible extension for a microSD card with a length of 25 cm. Supports all capacities and card types, including: 16 GB, 32 GB, 64 GB, 128 GB Micro SD/SDHC.

V-shaped plastic welding staples to repair cracks in internal corners. To repair a crack, place the tip parallel to the crack line.

The shield allows for easier connection of cables to the Arduino UNO R3 board. Thanks to the screw connectors, it is possible to fast and secure the cable, goldpin connectors allow you to easily connect the servo, and the built-in female connectors allow you to put additional Arduino shields

Evaluation kit with LittleBee GW1NR9 FPGA. It offers 8640 LUTs, 6480 Flip-Flops (FF), and has a built-in 8MB (64Mb) SDRAM. The board has 8 MB Flash, FTDI for UART, 8 LEDs and a button. TEC0117-01

Laser distance sensor with a measuring range up to 4 m based on the ToF measurement technique. Communication with the module takes place via the I2C interface

The battery tester is a compact device that allows you to check in a very simple and quick way whether the batteries or rechargeable batteries we use are functional. Our devices require good batteries or accumulators and we are often not sure if our equipment has the right power supply to withstand, for example, during a trip or celebration. Nothing easier, you can check it using a tester.

Micro digital servo equipped with a metal gear. Dedicated to flying models and rudder drive. FEETECH SCS2332

Single board computer with NXP i.MX 8M processor with 2 GB of DDR4 memory, Gigabit Ethernet port, two USB 3.0 ports, HDMI output, MIPI-DSI, MIPI-CSI, WiFi, Bluetooth Low Energy and MicroSD card slot. MaaXBoard AES-MC-SBC-IMX8M-G

Universal service holder for repairing printed circuit boards. Enables quick and stable mounting of the plate in the clamps

Set of 10 soldering tips from the 900M series - 900M-T-2.4D/2C/I/1.2D/3C/4C/K/3.2D/B/I (12J). Suitable for soldering stations of manufacturers Aoyue, Repro, Yihua, WEP, Quick