There are 5340 products.
5mm LED RED blinking (blinking), type 4V 15mA 200mcd 2Hz
Silicone cover for the heating block of a V6 type 3D printer. Provides an increase in nozzle temperature stability, especially when cooling by air flow
A set of two crocodile clips (terminals) in the form of caps for multimeter probes. 51mm clips length, supplied with black and red cover.
Frequency generator module with Si5351 chip based on 25 MHz quartz. The system has three independent, programmable clock outputs that can generate a clock signal in a wide range from 8 kHz to 160 MHz
Adapter SOP14 on DIP14 in the form of a PCB. It will be used as a programmer adapter, contact plates or prototype structures.
10-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends
The MX-5566-08 socket is a 8-pin, straight compactible with Mini-Fit Jr. connector with a 4.2 mm pitch, designed for wire-to-board mounting. Engineered for reliable power and signal transmission, it is commonly used in industrial equipment, computer systems, and power supply applications.
Board with USB-Type A connector (male) with USB lines connected to the goldpin connector (2.54mm)
3p male plug angled for PCBs, 2.54mm thick, tinned, white color. Set of 10 pieces
Large heat sink in the form of a case covering the entire board with double fan. Designed for Raspberry Pi 4 minicomputers.
5A car fuse is a key protection element for vehicle electronic systems, supplied in a set of 10, small in size and easy to replace
Threaded pipe used to connect the heat sink and heating block, contains a Teflon tube in the middle, adapted to a 1.75 mm filament
10 mm Ultra White LED, 10 degree angle; light intensity 25000 mcd (20mA) (3.2V)
Adapter QFN20 to DIP20 in the form of a PCB. It can be used as an adapter for a programmer, breadboards or prototype structures
LED 5 mm tri-color angle 60 degrees, common anode, Orange - light intensity 45 mcd (20mA) (2.05V); df 632 nm, Green - light intensity 45 mcd (20mA) (2.25V); df 568 nm
A set of 10 pieces of female-female connecting cables with a length of 21 cm. CAB_F-F (BK-10-25)
Evaluation kit equipped with equivalent of STM32F103C8T6 microcontroller (ARM Cortex M3, 72MHz, 64kB Flash, 20kB SRAM). It has two 20-pin connectors enabling the use of numerous microcontroller peripheral systems
1-channel LED dimmer with a maximum output current of 8 A. Works with LED power supplies with a voltage from 12 to 24 V
The SMA male connector is a durable and reliable coaxial connector with high strength and a wide range of applications
