List of products by brand DFRobot

Audio module with 8 Ohm loudspeaker and 8002B amplifier. It can be used as a buzzer and also play high-quality sound. The volume is controlled by a potentiometer. DFRobot FIT0449

Wireless charging uses an electromagnetic field to transfer energy between two objects. This is usually done with a charging station. DFR0362

NPN to PNP signal converter. Equipped with overvoltage protection and overcurrent protection. DFRobot FIT0850

8-port I2C splitter module. The board is equipped with a Gravity connector and allows you to connect additional I2C devices. DFRobot DFR0759

Module with a pulse sensor and SpO2 level (oxygen saturation level). It is based on the MAX30102 chip and MCU with heart rate and oximetry algorithm. Sensor communicates via the I2C interface. DFRobot SEN0344

Bluetooth 5.0 module based on the BT401 chip. It allows you to send audio and support microSD cards up to 128 GB. DFRobot DFR0781

Two-channel DC motor driver based on the HR9933 circuit. It allows you to control the movement of drives with a supply voltage of up to 10 V and power consumption up to 1.5 A. DFRobot DRI0040

Module with MOSFET transistor, 5-36 V, 20 A, switching frequency 1 kHz. DFRobot DFR0457

Module with an analog AC current sensor in a set with a probe for non-contact measurement of alternating current with a current of up to 10 A. DFRobot SEN0288

The low-power consumption micro-controller intentionally designed for Internet of Things (IoT) projects. The board integrates a Dual-Core ESP-WROOM-32 module, which supports MCU and Wi-Fi &Bluetooth dual-mode communication. DFR0478

(DFR0009) LCD Keypad Shield for Arduino

DFR0464

Designed for Sharp GP2D12/2D15/GP2Y0A02YK. FIT0005-OE

Gravity: I2C ADS1115 The 16-Bit ADC Module is an analogue-to-digital converter module for Arduino and Raspberry Pi. This module uses 16-bit ADC ADS1115 and is powered by 3.3 ... 5V. DFRobot DFR0553

An expansion board designed for the Raspberry Pi Pico. The board has 13 GPIO pins, 3 ADCs, UART, I2C and SPI interfaces. The pins are color coded according to the Gravity standard. DFRobot DFR0848

WiFiBee-MT7681 is an XBee module based on the MT7681 Wi-Fi module. WiFiBee supports standard IEEE802.11b / g / ni protocols. Can be used as a remote programmer for Arduino tiles. It is powered by 3.3 V. DFRobot TEL0107

DFR0275

Kit for building a simple educational robot Maqueen micro:bit chassis with engines, distance sensor, battery basket and necessary assembly elements. DFRobot ROB0148

A module with a MEMS microphone that will allow you to detect a voice, a clap or a door slam. The board has an analog output. DFRobot SEN0487

Carrier board dedicated to Raspberry Pi CM4 modules. It is equipped with two Ethernet connectors, a microSD slot and a USB connector. It allows you to build a small router. DFRobot DFR0767