MAX30102 Heart Rate and Oximeter Sensor V2.0 - module with a heart rate monitor chip

Muscle Sensor Surface EMG Electrodes allow you to control your projects with your muscles. Adafruit 2773

Module with a pulse sensor and the level of SpO2 (oxygen saturation level). It is based on the MAX30102 chip and communicates via the I2C or UART interface (Gravity connector). DFRobot SEN0518

SEN-12969

Module with heart rate and SpO2 sensor (oxygen saturation level) MAX30100 designed for M5Stack sets. M5Stack U029

The module with the MAX30100 chip that monitors the oxygen content in the blood and the heart rate. It consists of two LED diodes, a photodetector, optimized optics and low noise analog signal processing. modMAX30100

Module with an EMG signal detector. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020058

Kit for measuring muscle activity using electromyography (EMG). Contains everything you need from the MyoWare 2.0 ecosystem to test basic configurations in your applications. SparkFun KIT-25332

Module with a pulse sensor and the level of SpO2 (oxygen saturation level). It is based on the MAX30102 chip, dedicated to the T-Wristband

Disposable biomedical electrodes that allow you to perform experimental ECG measurements. DFRobot FIT0510

Heart rate measurement module compatible with Arduino and Raspberry Pi (Gravity: Heart Rate Monitor Sensor For Arduino). It uses PPG technique, which in a simple and cheap way is able to measure the changing volume of blood. DFRobot SEN0203

Designed to pair with the MyoWare Muscle Sensor; 10-segment bar graph shows the magnitude of the measured signal. The more muscle activation measured, the higher up the board the lit LEDs will go. DEV-13688

The module with a heart rate sensor and the SpO2 level dedicated to micro:bit. It is based on the MAX30102 chip and communicates via the I2C interface. SparkFun SEN-15271

Module with GSR skin resistance sensor. It is used to measure skin activity, which reflects the stress response and experienced emotions. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020052

Iduino SE049 is a simple and functional heart rate sensor, ideal for educational and hobbyist projects in the fields of electronics and bioengineering. Thanks to its compatibility with Arduino and intuitive operation, it allows for the creation of custom measurement devices such as pulse meters or smart health-monitoring wristbands. It is suitable for mobile and stationary applications as part of a diagnostic or training system.

Module with a pulse sensor (heart rate). The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 103020024

Evaluation board with built-in AD8232 heart monitor module and components placed in a way allowing effective implementation of medical and fitness applications, configuration of 2 or 3 electrodes