Category: RFID
There are 44 products.
The dynamic NFC / RFID tag with I2C bus and ISO 15693 RF interface in the SOIC8 housing has a built-in 64k EEPROM memory. Producer: STMicroelectronics
KAmodNFC is an expansion board with M24LR64E-R chip – dynamic tag with 64kb EEPROM memory and dual communication interface (I2C/RF). On board is placed also signalization of energy harvesting function, which is in M24LR64E-R chip embedded.
RFID identification key with dimensions of 40.5 mm x 32 mm x 4.2 mm, operating on the 13.56 MHz frequency. RFID Tag Key
The RFID / NFC transponder reader module (tags) works in the PN532 chip and is compatible with Arduino. Data is available via SPI, I2C or HSU (High Speed UART). Supplied with a RFID card and key ring. ELECHOUSE NFC MODULE V3
NFC module designed for Arduino. Meets the standards of reader mode, P2P mode and card emulation mode. The board has an integrated RF antenna. NXP OM5578/PN7150ARDM
RFID card with dimensions 54 mm x 85.5 mm x 0.87 mm, working on the 13.56 MHz frequency. RFID Tag Card
The 13.56 MHz RFID reader module in a set with a keyring and RFID card
A small key ring with an RFID tag for systems operating at 125 KHz. Provides the ability to read and write a unique ID number
Handheld RFID card reader enabling card duplication. It allows you to read data from one card and write it to the other
RFID Reader/Transponder IC 13.56MHz ISO 14443 I2C, SPI, UART, -25..85C, VFQFN32, NXP
NFC reader with USB interface. It allows you to easily read data from an NFC/RFID card using a computer. JT308
The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away. These can be read by almost any 13.56MHz RFID/NFC reader. Adafruit 360
A NFC-compatible Raspberry Pi expansion kit with integrated antent. It has the ability to work in reader mode, P2P
and card emulation mode. NXP PN7150
Module with RFID 125 KHz tag reader. It allows reading 125KHz RFID tags / cards (EM4100 standard) from a maximum distance of 7 centimeters. The module has a connector in accordance with the Grove standard. Seeed Studio 113020002
The X-NUCLEO-NFC03A1 is an NFC card reader evaluation board based on CR95HF / ST25R95-VMD5T to enable expansion of the STM32 Nucleo boards
Module with RFID reader. It is equipped with a buzzer and communicates via UART or USB interface. SB Components 20669
A module with an NFC PN532 transceiver, which supports proximity communication at the frequency of 13.56 MHz. The board is equipped with a Grove connector and communicates via the I2C or UART interface. Seeed Studio 113020006