Category: Wyzwalacze USB PD
There are 13 products.
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output in the form of pads. Allows powering devices with 20V. PDC004
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and a USB type A output. It enables powering devices with 15 V or 20 V and testing chargers. PDC005
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output in the form of pads. Allows powering devices with 15V. PDC004
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and a USB type A output. It enables powering devices with 9 V or 12 V and testing chargers. PDC005
Module with the HUSB238 chip, which allows for flexible configuration of the voltage and current supplied through the USB PD port. It allows both manual setting of parameters using jumpers and dynamic control via the I2C bus. Equipped with a USB Type C connector. Adafruit 5807
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and output on pads. Allows you to power devices with 5 V, 9 V, 12 V, 15 V and 20 V and test chargers by replacing the PD device
Power module with a USB Type-C connector based on the STUSB4500 system. It enables powering devices with voltages ranging from 5 V to 20 V and currents up to 5 A. Configuration via the I2C interface. SparkFun DEV-15801
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and USB typ A output. Allows you to power devices with 5 V, 9 V, 12 V, 15 V and 20 V and test chargers by replacing the PD device
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and output on pads. It enables powering devices with 9 V or 12 V and testing chargers. PDC005
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and output on pads. It enables powering devices with 15 V or 20 V and testing chargers. PDC005
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output on a 5.08 mm ARK screw connector. Allows you to power devices with 5 V, 9 V, 12 V, 15 V and 20 V and test chargers by replacing the PD device
No product available!
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output in the form of pads. Allows powering devices with 9V. PDC004
No product available!
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output in the form of pads. Allows powering devices with 12V. PDC004
No product available!