Category: Arduino Shield - extensions
Subcategories
There are 151 products.
KAmodNFC is an expansion board with M24LR64E-R chip – dynamic tag with 64kb EEPROM memory and dual communication interface (I2C/RF). On board is placed also signalization of energy harvesting function, which is in M24LR64E-R chip embedded.
9-axis expansion module with motion sensors. The module combines two integrated circuits: FXAS21002C 3-axis gyroscope and FXOS8700CQ 6-axis accelerometer/magnetometer. The board is equipped with connectors compatible with Arduino R3. NXP FRDM-STBC-AGM01
NFC module designed for Arduino. Meets the standards of reader mode, P2P mode and card emulation mode. The board has an integrated RF antenna. NXP OM5578/PN7150ARDM
Multifunctional expander (shield) for NUCLEO and Arduino equipped with Bluetooth 2.0+EDR (HC-05) interface, MEMS 3DoF LIS35, LED-RGB, joystick and analog STLM20 temperature sensor developed and produced by KAMAMI.
Extension board for Arduino Nano and Uno, 14 GPIO lines, connectors with I2C and UART interface lines. The board also has a RESET button and a voltage stabilizer
4inch Touch LCD Shield for Arduino is an overlay with a 4-inch LCD display. The screen has a resolution of 480x320 pixels. Communication with the display is via the SPI interface. Waveshare 4inch TFT Touch Shield
The overlay allows for easier connection of wires to the Arduino UNO R3 board. Thanks to the screw connections, it is possible to fast and securely fix the cable, and the built-in female connectors allow the application of additional Arduino shields. Screw shield
LED matrix display module (in blue color) with an organization of 14 columns x 9 lines, compatible with Arduino.
The Arduino Ethernet Shield 2 allows an Arduino Board to connect to the internet. It is based on the Wiznet W5500 Ethernet chip. The Wiznet W5500 provides a network (IP) stack capable of both TCP and UDP. There is an onboard micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino Uno and Mega
Base Shield V2 is an extension for tiles with an Arduino shield connector, it has a Grove connector, which can be connected to Grove-compatible modules / sensors. Seeedstudio 103030000
Voltage divider module for measuring quantities in the 0V to 25V range.
Motor-driven expansion board for Arduino, L293D, 74HC595 shift register, RoHS
Ethernet board with mini SD card slot based on W5100 controller.
Shield for STM32 series Nucleo, XNucleo and Arduino series for communication via RS485 and CAN interfaces (CAN is only available for Nucleo and XNucleo plates). Shield is based on MAX3485 and SN65HVD230 systems
WiFiBee-MT7681 is an XBee module based on the MT7681 Wi-Fi module. WiFiBee supports standard IEEE802.11b / g / ni protocols. Can be used as a remote programmer for Arduino tiles. It is powered by 3.3 V. DFRobot TEL0107
Shield with DC motor driver for Arduino. It has an operating voltage of 7 to 30 V and a maximum continuous current of 10 A. It can be controlled by a PWM signal or by means of built-in buttons. Cytron SHIELD-MD10
The shield allows for easier connection of cables to the Arduino UNO R3 board. Thanks to the screw connectors, it is possible to fast and secure the cable, goldpin connectors allow you to easily connect the servo, and the built-in female connectors allow you to put additional Arduino shields