Category: Peripheral modules
There are 77 products.
A 16-bit DAC converter module designed to work with M5Stack sets. It enables the conversion of analog signals into a digital signal. M5Stack ADC Unit
Battery with a capacity of 190 mAh designed to power the M5ATOM series modules. M5Stack T001
Prototyping kit designed for sets from the M5ATOM series. It includes a prototyping board and numerous connectors. M5Stack ATOM HUB DIY Proto
Module with color sensor TCS3472. The board is equipped with a Grove connector and communicates via the I2C interface. M5Stack U009
The module is equipped with two buttons in red and blue. It communicates via a digital interface and allows you to add simple controls to your M5Stack based project. M5Stack U025
Module with a PIR motion sensor designed for M5Stack modules. It can detect movement up to 5 meters with a detection angle of 100 degrees. M5Stack U004
Module with three Hall sensors A3144E, which react to the failure of the magnet. It is powered with 5 V and has a digital output on the Grove connector. M5Stack U084
Module with laser distance sensor ToF VL53L0X designed for M5Stack sets. It can detect simple hand gestures. M5Stack U010
12-bit DAC converter module designed to work with the M5Stack sets. It enables the conversion of digital signals into an analog signal. M5Stack DAC Unit
6-port I2C port expander for M5Stack sets. It allows you to connect several devices with the same address to one I2C bus. M5Stack U040-B
The module with a fingerprint sensor FPC1020A is designed for the M5Stack sets. The sensor has a built-in memory and can store up to 150 fingerprints. M5Stack U008
Module with heart rate and SpO2 sensor (oxygen saturation level) MAX30100 designed for M5Stack sets. M5Stack U029
Module with 6-axis IMU sensor MPU6886, which combines a 3-axis accelerometer and a 3-axis gyroscope. M5Stack U095
The CAN transmitter and receiver module is intended for M5Stack sets. It is based on an isolated CA-IS3050G transceiver system, which can provide differential data reception and transmission. M5Stack U085
A module with a 433 MHz radio transmitter for the M5Stack sets. Based on the SYN115 chip, it has a built-in PCB antenna. M5Stack U114
ToF VL53L0X distance sensor module designed for M5Stack sets. It allows you to measure distances up to 2 m and communicates via the I2C interface. M5Stack U072
MEMS SPM1423 digital microphone module with PDM modulation. It communicates via the I2S interface. M5Stack U089
Module with a passive buzzer designed for M5Stack sets. It is equipped with a Grove connector and is controlled by a square signal. M5Stack U132
The module with the relay is designed for the M5Stack sets. It allows you to control devices with a working voltage of up to 220 V AC and a current of up to 3 A or a voltage of 30 V DC and an intensity of 3 A. M5Stack U023
Isolated UART-RS485 converter designed for M5Stack sets. It allows communication within an industrial serial interface. M5Stack U094