Category: Encoders
There are 31 products.
The module is equipped with an AS5600 magnetic encoder with a resolution of 12-bit. It allows for non-contact measurement of the angle of rotation. The module has an analog/PWM output and an I2C interface.
Module with an incremental encoder with a rotation range of 360° and a button. Communicates via a digital interface. DFRobot SEN0235
Set of two magnetic encoders for use with micro motors. Side mounting, set of 2. Pimoroni PIM605
Module with an incremental encoder with a rotation range of 360° and a button. Communicates via a digital interface
Pololu - 3498
Set of two magnetic encoders for use with micro motors. Regular mounting, set of 2. Pimoroni PIM604
Incremental encoder (horizontal) with a resolution of 15 pulses per revolution. Equipped with a switch
The module is designed to support incremental encoders. It reads the rotation of the encoder and transmits the information via the I2C interface. Adafruit 4991
The kit uses a magnetic disc and hall effect sensors to provide 12 counts per revolution of the motor shaft. The sensors operate from 2.7 V to 18 V and provide digital outputs that can be connected directly to a microcontroller or other digital circuit. Compatible with all of the dual-shaft micro metal gearmotors we carry, including the HPCB versions. Pololu 3081
Pololu - 1524
Absolute encoder module with 8421 (BCD) coding with 16 positions. Vertical mounting. DFRobot DFR0721
Module with encoder and RGB backlight. It has an unlimited range of motion and is perfect for e.g. lighting control. Pimoroni PIM522
AB two-phase pulse wave, measured by two infrared reflective sensor. These two sensor pulse waveform is close to a phase difference of 90 degrees, through the AB two-phase lead and lag of the waveform judged wheel forward rotation or the reverse. SEN0116
A set of two magnetic encoders for use with Pololu DC Micro motors. The maximum resolution is 12 pulses per one revolution of the motor shaft. Powered from 2.7V to 18V. Pololu 4760
The module is designed to support incremental encoders. It reads the rotation of the encoder and transmits the information via the I2C interface. It has two built-in STEMMA QT connectors. Adafruit 5740
Gravity: 360 Degree Hall Angle Sensor is a rotation angle sensor measuring a value in the range of 0-360 ° with an analogue output, powered by 5V. DFRobot SEN0221
Add quadrature encoders to your 20D mm metal gearmotors (extended back shaft version required) with this kit that uses a magnetic disc and Hall effect sensors to provide 20 counts per revolution of the motor shaft. The sensors operate from 2.7 V to 18 V and provide digital outputs that can be connected directly to a microcontroller or other digital circuit.
360° encoder module with LED indicators. It communicates via the I2C interface (Gravity connector). DFRobot SEN0502
Module with a digital rotary encoder controlled by the I2C interface. The potentiometer has RGB LED backlight. The encoder generates post-movement information with 24 levels per revolution and rotation direction detection. SparkFun DEV-15083