Category: Pressure sensors
There are 33 products.
The module allows you to attach a strain gauge (working in the Wheatstone bridge circuit) and convert the analog signal into its digital representation, available on the module output lines. The system processes the signal with a 24-bit resolution and can be powered by 2.7V - 5.5V. The module is especially recommended for constructing digital scales in combination with Arduino
Aluminum tensometer beam, allowing weight measurement up to 2 kilograms. It has four wires. It is used in kitchen scales and portable scales.
A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0294
Aluminum extensometer beam, allowing measurement of weight up to 20 kilograms. It has four wires. It is used in kitchen scales and portable scales, it has a 21 cm cable, RoHS.
Aluminum extensometer beam, allowing mass measurement up to 5 kilograms. It has four wires. It is used in kitchen scales and portable scales.
Aluminum extensometer beam, allowing weight measurement up to 3 kilograms. It has four wires. It is used in kitchen scales and portable scales.
Force-Sensing Resistor - 0.2" Circle
Aluminum extensometer beam, allowing measurement of weight up to 1 kilogram. It has four wires. It is used in kitchen scales and portable scales.
Aluminum extensometer beam, allowing weight measurement up to 100 kilograms. It has four wires. It is used in kitchen scales and portable scales, max 100 kg, 20x23x94, 21 cm cable, RoHS
Force-Sensing Resistor - 0.5" Circle
Grove module with FSR402 pressure sensor. The board is equipped with a Grove connector with an analog output. Seeed Studio 101020553
A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0298
A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. SEN-10264
Deflection sensor 114 mm long. The sensor resistance changes with the bend angle. At the end, the sensor has a 2-pin connector with a pitch of 2.54 mm. SparkFun SEN-08606
Set with the ADC HX711 transducer module and a pressure sensor in the form of a tensometric beam. It communicates via the UART interface. It allows you to build a simple home scale. DFRobot SEN0160
SEN-11207 - Flexiforce Pressure Sensor - 25lbs (1" area)
Force-Sensing Resistor - 1.5" Square
The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878
Round, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0297