Category: Bluetooth modules
There are 80 products.
KAmodBT-HC05 is a Bluetooth module configured via AT commands. It has integrated LEDs indicating operating mode and connection status with the paired device, as well as a logic level translator on UART lines. KAmodBT-HC05
Integrated circuit, combining Wi-Fi functionality and Bluetooth 4.2 BLE. Integrated 32-bit dual-core Xtensa LX6 processor, 448kB ROM, 520kB SRAM. ESP32 allows you to work with many interfaces, including SPI, I2C, UART, CAN, ETH, IR and can be supplied with 2.2V-3.6V. The system has a QFN48 (5x5mm) housing. ESP32-D0WD
Bluetooth module v2.0 + EDR (master / slave), controlled by AT + commands with built-in antenna.
Bluetooth module v2.0 + EDR, controlled by AT + commands with built-in antenna.
Bluetooth module with built-in CC2541 chip. The module is small, energy-saving and easy to use
Bluetooth 5.1 module (BLE, SPP) designed to work with the Raspberry Pi Pico. It communicates via the UART interface using AT commands. Waveshare Pico-BLE
HC-08 is a module operating in the Bluetooth Low Energy 4.0 standard. The system has a built-in antenna and small dimensions, and thanks to edge joints it can be surface soldered. The module is configured via AT commands
Bluetooth module with integrated HC-08 system. Thanks to the angular pin connector with the bus signals, it is possible to easily connect the module to the contact plate or wires
A module with a USB connector that supports WiFi communication (two frequency bands 2.4GHz and 5GHz) and Bluetooth 2.1/3.0/4.2. Dedicated to Odroid minicomputers. Odroid WiFi Module 5BK
Bluetooth 4.0 dongle as a USB adapter. Works with bluetooth devices such as speakers, headsets, smartphones, tablets, keyboards, mice, printers, projectors etc.
USB adapter for PC, allowing Bluetooth v4.0 communication with speeds up to 3Mb / s and range up to 20m
Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna, microphone, 3.5 mm audio jack and control buttons
A module that combines GSM/GPRS/GNSS and BT 3.0 technologies. It is available in a small, easy to solder LCC housing and has a low power consumption up to 1.2 mA. Quectel MC60CA
Powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32E 32MBit (4MB)
Mini bluetooth v2.0, plug & play USB module, RoHS
Bluetooth 5.0 module based on the BT401 chip. It allows you to send audio and support microSD cards up to 128 GB. DFRobot DFR0781
Bluetooth 4.0 module based on the CSR8635 chip designed for Bluetooth audio applications. The module has a built-in antenna and pins for edge connectors.
Bluetooth 4.0 BLE module with UART serial interface. Controlled by AT commands, it can be supplied with the voltage from 3.6 V to 6 V. AT-09/HM-10
Waveshare BLE4.0 Bluetooth 2.4G Mother Board, provides I/O expansion connectors and various interfaces. BLE400