Bluetooth module HC-05 (2.0 + EDR)

HC-08 is a module operating in the Bluetooth Low Energy 4.0 standard. The system has a built-in antenna and small dimensions, and thanks to edge joints it can be surface soldered. The module is configured via AT commands

Board with the Artemis chip, the GNSS ZOE-M8Q module and the Iridium 9603N satellite receiver. It allows you to send and receive short messages with data anywhere in the world. SparkFun WRL-18712

An integrated module combining WiFi, Bluetooth 4.0 and FM radio. It has derived SDIO, UART and PCM interfaces. Ampak AP6335

ModCC2540-A1 allows the use of Bluetooth transmission features BLE 4.0 - thanks to the built-in CC2540 chip, it is possible to create complex projects without the use of an additional microcontroller. modCC2540-A1

The Pmod BLE module is a Bluetooth module with powerful capabilities. Thanks to communication via the UART port, the module can be connected to any platform equipped with this interface. The module is equipped with the Roving Networks RN4870 system, in which a full Bluetooth interface is built-in. Digilent 410-359

Integrated circuit, combining Wi-Fi functionality and Bluetooth 4.2 BLE. Integrated 32-bit dual-core Xtensa LX6 processor, 448kB ROM, 520kB SRAM. ESP32 allows you to work with many interfaces, including SPI, I2C, UART, CAN, ETH, IR and can be supplied with 2.2V-3.6V. The system has a QFN48 (5x5mm) housing. ESP32-D0WD

The module with the HC-05 transceiver makes it easy to add Bluetooth communication to an existing project. The system is controlled by exchanging AT commands (UART bus). FC-114

The low-power consumption micro-controller intentionally designed for Internet of Things (IoT) projects. The board integrates a Dual-Core ESP-WROOM-32 module, which supports MCU and Wi-Fi &Bluetooth dual-mode communication. DFR0478

Bluetooth 5.0 module based on the BT401 chip. It allows you to send audio and support microSD cards up to 128 GB. DFRobot DFR0781

Low Energy Bluetooth adapter module with USB 2.0 connector. allows communication with BLE devices

Crowtail – Bluetooth-compatible Low Energy Module is a small BLE + EDR communication module intended for wireless data transmission in IoT and automation projects. It enables fast serial-interface connection with mobile devices or computers.

AW-CB375NF wireless communication module. It supports 802.11 a/b/g/n/ac Generation 5 Wi-Fi and Bluetooth 5.0 and features an M.2 A/E Key connector. Waveshare Wireless-AW-CB375NF

A development board that combines the u-blox NINA-B306 Bluetooth module, the ISM330DHCX 6DoF IMU sensor, and the BME280 atmospheric pressure sensor. It has a built-in Qwiic connector and LiPo battery connector as well as a charger and LiPo parameters monitor. SparkFun WRL-20854

Intel\'s AX210 wireless communication module. It supports 802.11AX Wi-Fi Generation 6E and Bluetooth 5.2, and comes with an M.2 A/E Key connector. Waveshare Wireless-AX210

Advanced wireless communication module, based on the Bluetooth 5.4 stack (Bluetooth® Low Energy, BLE), which was designed using the efficient Nordic NRF52805 SOC system. The module offers support for the UART interface, available only in peripheral mode, which allows for effective operation as a data bridge (Data Bridge). Sparkfun WRL-25466

A compact development board that uses the ESP32-PICO-MINI chip. It provides wireless communication via Bluetooth and serves as an easy-to-configure UART converter. It has a built-in PCB antenna. SparkFun WRL-23287