Artemis Global Tracker - board with Artemis chip, GNSS module and satellite receive
ID: 588764
zł3,500.97
Tax included
zł2,846.32 tax excl.
Board with the Artemis chip, the GNSS ZOE-M8Q module and the Iridium 9603N satellite receiver. It allows you to send and receive short messages with data anywhere in the world. SparkFun WRL-18712
Description
Board with the Artemis system, the GNSS ZOE-M8Q module, the Iridium 9603N satellite receiver and the TE MS8607 pressure, humidity and temperature sensor. It allows you to send and receive short messages with data, and using the Iridium satellite network, it works anywhere in the world, including the polar regions, far beyond the range of WiFi and GSM networks.
The heart of the board is the Artemis module compatible with Arduino. It comes with 1MB of flash memory and 384KB of RAM and has a Qwiic connector, so you can easily connect external I2C sensors. In addition, the I2C and SPI pins were led out along with five digital I / O and five GPIO pins. The ZOE-M8Q enables AGT to quickly and accurately determine the location with minimal power consumption. The ZOE and Iridium modem share one antenna, and the AGT has a switching circuit for selecting which device uses the attached antenna. The built-in pressure, humidity and temperature sensor of the MS8607 operates in temperatures down to -40 ° C and 10 mbar, making it ideal for use in harsh environments.
The module is powered by a USB type C connector, a LiPo battery or an external battery pack. Has a built-in LiPo charger. The user can also add additional supercapacitors and configure the AGT current consumption so that the Artemis Global Tracker can be powered directly from the very small solar panel. Full documentation with examples of use is available on the product page.
Attention!
The Iridium modem requires a monthly service to exchange information with the Iridium satellite network, which must be purchased from Ground Control (also known as Rock Seven) via the admin portal after devices are registered. If you want to use it with another provider, you will have to pay an unlock fee.
The Iridium modem requires a monthly service to exchange information with the Iridium satellite network, which must be purchased from Ground Control (also known as Rock Seven) via the admin portal after devices are registered. If you want to use it with another provider, you will have to pay an unlock fee.
Features
-
Artemis Processor
- 1M Flash / 384k RAM
- 48MHz / 96MHz turbo available
- 68A/MHz (operates less than 5mW at full operation)
- Integrated BLE radio and antenna
- FCC/IC/CE Certified (ID Number 2ASW8-ART3MIS)
-
Iridium 9603N Satellite Transceiver
- Truly global operation, using the Iridium satellite network
- Powered through two 1F supercapacitors
- Charged by a LTC3225 supercapacitor charger
- ADM4210 in-rush current limit circuit
-
ZOE-M8Q GNSS Receiver
- 72-Channel GNSS receiver
- 2.5m Horizontal Accuracy
- Time-To-First-Fix:
- Cold: 26s
- Hot: 1s
- Max Altitude: 50,000m
- Max G: ≤ 4
- Max Velocity: 500m/s
- Velocity Accuracy: 0.05m/s
- Heading Accuracy: 0.3 degrees
-
MS8607 Pressure, Humidity and Temperature Sensor
- Operating Ranges:
- 10 - 2000mbar
- 0 - 100% Rh
- -40 - 85°C
- Accuracy (@25°C)
- ±2mbar
- ±3%Rh
- ±1°C
- Operating Ranges:
-
Power Options:
- USB-C
- LiPo Battery
- Solar Panel or Battery Pack (max 6V)
- SMA antenna connector for both 9603N and ZOE-M8Q (with integrated protection circuit)
- MCP73831 LiPo Charge Management for single-cell LiPo batteries
- Qwiic Connector
- PTH connections for I2C, SPI, Reset, 5 digital I/o and 5 GPIO pins
588764
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Available
Cable with USB typ A and USB typ C connectors, cable length 0.5 m. LANBERG
zł4.26
24h
Available quantity: 9
Available
Cable with USB typ A and USB typ C connectors, cable length 1 m. LANBERG CA-USBO-10CC-0010-BK
zł5.71
24h
Available quantity: 33
Available
Cable with USB typ A and USB typ C connectors, cable length 1,8 m. LANBERG CA-USBO-10CC-0018-BK
zł5.61
24h
Available quantity: 47
Available
SparkFun Qwiic kit. Contains 10 wires of different lengths and tips. It allows you to connect Qwiic modules to a programming platform or to a prototype board. SparkFun KIT-15081
zł54.89
24h
Available quantity: 5
Available
Other products in the same category (16)
GNSS receiver based on the UM980 module. It allows you to track signals from several satellite systems, including GPS, GLONASS, Galileo, Beidou, QZSS and SBAS, and offers an accuracy of up to 8 mm using an RTK base station. SparkFun GPS-23286
zł1,586.21
3 weeks
No product available!
Module with GPS PA1616D receiver based on the MTK3333 system. It is equipped with a USB type C connector and a USB-UART converter. Adafruit 4279
zł155.07
4 weeks
No product available!
The set with the RM500Q-GL module is designed to work with the Raspberry Pi minicomputer. It supports 5G, 4G and 3G networks and supports GNSS positioning. Waveshare RM500Q-GL 5G HAT (EU)
zł1,820.26
4 weeks
No product available!
GPS module with GNSS receiver ZED-F9T. It supports L1 / L2 / E5b bands and provides clocking accuracy of up to five nanoseconds. Qwiic connector. SparkFun GPS-18774
zł1,838.15
3 weeks
No product available!
GPS module with LC29H GNSS receiver designed to work with the Raspberry Pi minicomputer. It allows you to receive data from major positioning systems, including GPS, QZSS, GLONASS, Galileo and BeiDou, and supports positioning assistance systems (WAAS, EGNOS, MSAS and GAGAN) and EASY technology. Waveshare LC29H(AA) GPS HAT
zł207.17
24h
Available quantity: 1
Available
GNSS receiver module dedicated to Raspberry Pi minicomputers. It provides simultaneous reception of up to three types of satellite systems, including GNSS with GPS, Beidou, Galileo and GLONASS. Waveshare NEO-M8T GNSS TIMING HAT
zł599.59
4 weeks
No product available!
Universal communication module supporting 4G/3G/2G connectivity and GNSS systems, ideal for applications in monitoring, logistics and alarm systems. Thanks to UART and USB interfaces, as well as compatibility with Windows, Linux and Android systems, it can operate as a standalone device or an external network card. Support for AT commands, TCP/IP protocols and voice functions make it a versatile tool for IoT and embedded projects. DFRobot TEL0161
zł312.15
4 weeks
No product available!
Works with C1 / U3 / XU3 / XU4 / C0 / C2 Android and Ubuntu OS
zł149.38
24h
Available quantity: 1
Available
GNSS receiver to receive navigation signals from satellite navigation systems such as GPS and BeiDou. It offers positioning accuracy of up to 2 m. DFRobot TEL0157
zł94.49
24h
Available quantity: 1
Available
GPS module with GNSS receiver ZED-F9P. It can receive data from GPS, GLONASS, Galileo and BeiDou systems. It has USB, UART, I2C and SPI interfaces. RTK and high accuracy up to 10 mm. SparkFun GPS-16481
zł1,499.00
3 weeks
No product available!
Available
Adafruit 1272 - Adafruit Ultimate GPS Logger Shield - Includes GPS Module
zł205.62
4 weeks
No product available!
Module with NEO-F9P GNSS receiver. It allows you to track signals from several satellite systems, including GPS, GLONASS, Galileo and Beidou, and offers accuracy of up to 10 mm using an RTK base station. It offers five communication ports: USB type C, UART1, UART2 for RTCM, I2C and SPI reception and Qwiic connectors. SparkFun GPS-23288
zł1,553.79
3 weeks
No product available!
GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. Built-in accelerometer and gyroscope. SparkFun GPS-16329
zł381.85
24h
Available quantity: 1
Available
Advanced precision positioning tool based on Septentrio\'s mosaic-X5 multi-constellation GNSS receiver, achieving 6 mm RTK accuracy. Supports GNSS signals from various systems, such as GPS, GLONASS, Galileo, Beidou, NavIC and L-band corrections, offering a position update rate of up to 100 Hz, making it ideal for robotic applications. The kit includes an internal web server for configuration, a National Geodetic Survey-certified GNSS antenna and a rugged aluminum housing for easy installation and reliability in harsh environments. SparkFun GPS-23748
zł6,667.62
3 weeks
No product available!
GPS module with LC29H GNSS receiver designed to work with the Raspberry Pi minicomputer. It allows you to receive data from major positioning systems, including GPS, QZSS, GLONASS, Galileo and BeiDou, and supports the RTK function as a base station. Waveshare LC29H(BS) GPS/RTK HAT
zł294.35
24h
Available quantity: 1
Available
Board with the Artemis chip, the GNSS ZOE-M8Q module and the Iridium 9603N satellite receiver. It allows you to send and receive short messages with data anywhere in the world. SparkFun WRL-18712