Category: Cables, housings and other camera accessories
There are 34 products.
Flex Cable for Raspberry Pi Camera - 300mm / 12"
Flex Cable for Raspberry Pi Camera - 200mm / 8"
Flexible cable (tape) 50 cm long, used to connect the camera module with Raspberry Pi computers. The tape has 15 wires and a pitch of 1mm
The adapter allows to extend the CSI / DSI interface using two FFC tapes (by connecting them in one tape). It allows you to connect the camera to a Raspberry Pi computer or a DSI display, for distances using two FFC tapes. Adafruit 3671
ArduCam CSI to HDMI modules are designed to work with cameras: Raspberry Pi V1 and Raspberry Camera V2. ArduCAM CSI to HDMI allows you to extend the signal from cameras using the HDMI <-> HDMI cable (up to 10 meters). Arducam B0091
Lens Mount Adapter for Canon EOS Lens to C-Mount, Compatiable with All EF, EF-S Lens to Raspberry Pi HQ Camera. ArduCAM UB0228
CAMDENBOSS CBRPC-CAR Dev Board Enclosure, Raspberry Pi Camera, Polystyrene, Carbon
Two modules with infrared LED lighting for the ArduCAM Raspberry Pi NOIR 5MP OV5647 camera. Can be widely used in wildlife night vision photography, agriculture, etc. ArduCAM B0035LED
Set with 2 DOF control platform for cameras designed for Raspberry Pi minicomputers. The platform is based on two digital servos that allow you to control the position of the camera in two dimensions. ArduCAM B0227
Adapter dedicated to Omnivision cameras. Allows you to connect an image sensor to the evaluation kit. ArduCAM B0012
300mm ArduCam extension cable. Compatible e.g. with IMX219 image sensor. ArduCam B0186
A set of metal handles to build a platform powered by micro servos. It allows you to create a movable stand, e.g. for a camera. SparkFun ROB-10335
Multifunctional lens calibration kit for M12, CS-Mount, C-Mount and DSLR lenses. It allows focus calibration, FoV measurement without the need for additional calculations and focusing. ArduCAM B0226
CAMDENBOSS CBRPC-CLR Dev Board Enclosure, Raspberry Pi Camera, Polystyrene, Transparent
Arducam USB shield is a module that allows you to connect some ArduCam cameras to a PC or minicomputers, eg Raspberry Pi, BeagleBone etc. The module supports most cameras with a serial interface that have a resolution of 0.3 ... 14 MPix. Attached to the module are appropriate libraries that facilitate image processing, eg using OpenCV software. ArduCam B0095
A set with a 2 DOF control platform for cameras designed for Raspberry Pi, Nvidia Jetson Nano and Xavier NX. It is based on two digital servos and dedicated board. ArduCAM B0283
A small tripod with 1/4" mounting screw designed for Raspberry Pi HQ Camera. Pocket-sized and very lightweight, withstands loads up to 1kg. ArduCAM UB0216
Nikon F-Mount lens mount adapter for C-Mount Raspberry Pi HQ. ArduCAM UB0218
The control platform equipped with servos allows you to control the position of the camera in two dimensions. It has a built-in driver and light sensor. Waveshare Pan-Tilt HAT
Adapter designed for cameras with a parallel interface. It allows you to connect the camera with the USB Camera Shield module and connect it to a computer via a USB port. ArduCAM B0345