Order and pay in
for same day shipping
Module with flashing multi-color LED. The board is equipped with a Grove...
Module with a purple LED diode. The board is equipped with a Grove...
Module with green LED diode and potentiometer. The board is equipped...
Module with a joystick with two analog axes (X and Y axis) with a button...
NUCLEO series starter kit equipped with a STM32WL55JC microcontroller...
Active cooling kit for Raspberry Pi minicomputers. It consists of a fan,...
HAT for powering over Ethernet (PoE) for Raspberry Pi. It allows you to...
Evaluation Kit with Bluetooth 5.0 BT401. It is equipped with a microSD...
Adafruit 2342
Adafruit 2217
Audio receiver with Bluetooth 4.2 module. It is powered by a microUSB connector and is equipped with 5 control buttons
This Bluetooth Audio receiver module includes a USB port and TF card slot. With a pre-amp output, you can drive headphones or a 3W speaker directly. You can also add an active power amplifier and connect a loudspeaker. The module supports MP3, WMA, WAV and lossless FLAC audio formats. DFRobot TEL0108
Gravity: UART MP3 Voice Module is an MP3 sound player module with a built-in 8 MB memory. It is powered by 3.3-5V and controlled by the UART interface. DFRobot DFR0534
Audio module based on a 32-bit PCM5102A DAC converter designed for cooperation with with Raspberry Pi minicomputers. Communication via the I2S interface. GY-PCM5102
MP3 player module controlled by the I2C interface. It is based on a class D amplifier with a power of 1.4 W. The board has a 3.5 mm headphone output and an 8 Ω speaker connector. Audio files are saved on the microSD card. SparkFun DEV-16892
MP3 player module controlled by the I2C interface. It is based on a class D amplifier with a power of 1.4 W. The board has a 3.5 mm headphone output and an 8 Ω speaker connector. Audio files are saved on the microSD card. SparkFun DEV-15165
SparkFun Papa Soundie Audio Player is a board with ATmega328P microcontroller and VS1000D chip, which allows you to play sounds (in OGG Vorbix and WAV format) stored on a microSD memory card. The board has a 3.5 mm jack connector. SparkFun DEV-14554
This is the Teensy Audio board add-on for the Teensy 3.x line development boards. This audio board provides you with an easy-to-use tool to add high quality 16 bit, 44.1 kHz sample rate audio to your Teensy project. DEV-12767
This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381
Music Shield for Arduino Development, Audio Play/Record, VS1053B Onboard