XY-BT-Mini - MP3 decoder module

WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21772

Audio module that allows you to play sounds from a USB memory, microSD card, via Bluetooth or FM radio. It is equipped with a microphone, 3.5 mm audio jack and control buttons

WAV files player module. It is based on a DAC converter and an audio amplifier, there is a 3.5 mm audio output on the board. The files are played from the microSD card. Adafruit 94

Adafruit 2217

Bluetooth 4.2 audio receiver with 3.5 mm jack audio output. It allows you to play files via Bluetooth and supports WAV, WMA APE, MP3 and FLAC formats. MH-M28

Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna, microphone, 3.5 mm audio jack and control buttons

Adafruit 2342

MP3 panel with a HiFi amplifier for installation in an audio device. It allows you to play files from USB memory, SD card, via AUX and Bluetooth. It has a built-in FM receiver

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

Audio receiver with Bluetooth 5.0 communication based on the QCC3008 module. It can be powered with the voltage from 3.6 V to 5.5 V, including with a lithium battery

WIG-13720

Stereo audio amplifier with Bluetooth communication. It can be powered with the voltage from 8 to 26 V and has two outputs with a power of 50 W. The set includes a remote control

Audio player with HiFi amplifier in aluminum housing. It allows you to play files from USB memory, SD card, via the audio connector and Bluetooth. It has a built-in FM receiver

Bluetooth 4.1 audio receiver with 3.5mm Jack audio output. It allows you to play files via Bluetooth, from mass memory (pendrive) or microSD card and supports WAV, APE, MP3 and FLAC formats. XY-BT-L

Bluetooth audio receiver module in the set with a 3.5 mm Jack adapter. It enables wireless transmission of sounds. It is equipped with a 3.5 mm audio jack, microUSB socket and control buttons

Audio module with DAC, amplifier, display and loudspeaker, designed to work with the Raspberry Pi. Pimoroni PIM485