Order and pay in
for same day shipping
KAmodLIS35DE is a module with a three-axis LIS35DE accelerator from...
Surface mount module with Edge TPU coprocessor. Supports TensorFlow Lite...
Single-board computer with SoC MediaTek 8167s chip, designed for use in...
ML accelerator module that allows the use of the Edge TPU coprocessor in...
Module with a matrix of 64 Hall sensors, which enables the conversion of...
GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive...
Keyboard with touchpad for Smart TV, low profile, with X-SCISSORS...
30-wire connection cable for the OpenScope MZ measuring adapter. It allows pins to be connected to the 2x15 male connector. The cable also allows you to easily connect the attachment to other sets. Digilent 310-099
A set of 10 colored wires with 50 cm long crocodile clips.
A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm intended for logic analyzers Saleae to cooperate with a ready-made connector on a PCB (both ends terminated).
BNC connector cable (adapter) for minigrabber clips. It enables the connection of the tested system with an oscilloscope
BNC connector cable (adapter) to the "Alligator clip" connector. It allows you to conveniently connect the device, e.g. to an oscilloscope. Digilent (240-134)
BNC connector adapter cable for mini-grabber clips. Connects to Analog Discovery 2 via a BNC adapter. Digilent 240-136
10-pin connection cable with a length of 20 cm, terminated with a female goldpin plug and alligator connectors
10-pin connection cable with a length of 20 cm, terminated with a male goldpin plug and alligator connectors
A set of 5 test clips with leads terminated with pins. Digilent 240-137
A set of two probes for a digital multimeter and crocodile clips. Clips make easier to measure parameters on threaded elements and connectors.
A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae
A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm, designed for Saleae logic analyzers unilaterally terminated.
A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae.
A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae.
Measuring probe for digital multimeter with clip with maximum opening of 10 mm. Ideal for measurements on SMD components.