Category: Segger programmers

10-wire ribbon cable (1.27mm to 2.54mm) for Segger J-Link EDU mini

J-LINK EDU Mini is a version of the J-Link EDU (8.08.90) in a reduced form factor with identical functionality for Cortex-M based targets. It has been designed to allow students and educational facilities as well as hobbyists access to top of the line debug probe technology. Version for non-commercial use only. J-Link EDU mini

J-Link Needle Adapter - connect J-Link to a PCB, Segger

JTAG/SWD Emulator with USB interface

JTAG/SWD Emulator for ARM7/9, Cortex and Renesas RX cores with USB interface, Segger

J-Link 9-pin Cortex-M Adapter, RoHS, Segger

J-Link 19-pin Cortex-M Adapter, RoHS, Segger

J-Link 6-pin Needle Adapter (8.06.16)

Standard 20-pin 0.1 male connector to provide electrical isolation, Segger

Hi-Speed JTAG/SWD Emulator with USB and Ethernet interface, Segger

J-Link BASE is a USB powered debug probe supporting a large number of CPU cores. Based on a 32-bit RISC CPU, it can communicate at high speed with the supported target CPUs. J-link BASE Compact (8.19.00)

Hi-Speed JTAG/SWD Emulator for ARM7/9, Cortex and Renesas RX cores with USB interface, Segger

Flash Programmer for ARM and Cortex cores, Segger

SiFive-ARTY adapter for debugging between J-Link and the ARTY board with SiFive RISC-V. Segger SiFive-ARTY Adapter (8.06.24)

AVR PDI adapter from standard 2.54mm 20 pin connector to 2.54mm 6 pin, 1.27mm 6 pin or 2.54mm 10 pin AVR PDI connector. Segger AVR PDI Adapter (8.06.26)

The mainboard is an element of the microcontroller and microprocessor programming system intended for production applications. Segger Flasher ATE Main Module (5.18.01)

Adapter that converts standard 20-pin 2.54 mm connector to SWIM connector and 10-pin connector. Used for programming STM8 chips. Segger STM8 Adapter (8.06.22)

A power adapter that provides a stabilized supply voltage to the target board (can be adjusted from 3.6V to 0.8V). Segger Target Supply Adapter (8.06.18)

An adapter that converts a standard 20-pin 2.54 mm connector to a 10-pin 2.54 mm connector. It enables the connection of Segger programmers with Silicon Labs devices and development boards with a C2 interface. Segger SiLabs C2 Adapter (8.06.17)

The RX FINE adapter converts a standard 20-pin 2.54 mm connector to a 14-pin 2.54 mm connector. It enables the connection of Segger programmers with RX devices from Renesas. Segger RX Fine Adapter (8.06.10)