Kit containing Raspberry Pi Pico and Raspberry Pi 4B 4 GB. The kit also...
Module with the RP2040 microcontroller with two ARM Cortex-M0 + cores...
Kit containing Raspberry Pi Pico and Raspberry Pi 4B 4 GB. The kit also...
Kit containing Raspberry Pi Pico and Raspberry Pi 4B 4 GB. The kit also...
Kit containing Raspberry Pi Pico and Raspberry Pi 4B 4 GB. The kit also...
Starter kit containing Raspberry Pi Pico, necessary connectors and a...
Module with a gas concentration sensor MQ2, which enables the detection...
Module with EEPROM memory, capacity 512 kbit (64kB). Communication takes place via the I2C interface. The module has 3 jumpers that enable selection of one of 8 addresses. SparkFun SPX-14764
I2C FRAM breakout board you can add some FRAM storage to your next DIY project. FRAM allows for a lower power usage and a faster write performance. Adafruit 1895
The EEPROM memory module with the built-in AT24C32D chip allows storing data without loss after switching off the power supply. MOD 50
The module with the EEPROM 24LC256 memory chip with a capacity of 32 kB. It is supplied with the voltage ranging from 2.5 V to 5.5 V and communicates via the I2C interface (Gravity connector). DFRobot DFR0117
FRAM chip has 64 Kbits (8 KBytes) of storage, interfaces using SPI, and can run at up to 20MHz SPI clock rates. Each byte can be read and written instantaneously (like SRAM) but will keep the memory for 95 years at room temperature. Adafruit 1897