Two-button module with 4 colored overlays. The board is equipped with a...
Grove vertical socket for surface mounting, 4-pin, pitch 2.0 mm. Set of...
A set with a radio transmitter and receiver operating at 315 MHz. The...
Module with the LIS3DHTR 3-axis accelerometer. The board is equipped...
The module with an incremental encoder with channels A and B. The board...
Module with driver for 64x32 or 32x16 LED matrix displays. The board is...
Module with SHT31 temperature and humidity sensor. The board is equipped...
An integrated module combining WiFi, Bluetooth 4.0 and FM radio. It has derived SDIO, UART and PCM interfaces. Ampak AP6335
Adafruit Feather HUZZAH ESP8266 is a new development board from Adafruit with a built-in WiFi module ESP8266. Processor frequency: 80 MHz, USB-serial TTL CP2104 converter, Li-Pol battery charger. Adafruit 2821
Connect your Arduino-compatible to the Internet with this WiFi shield that features the FCC-certified ATWINC1500 module from Atmel. Adafruit 3653
Connect your Arduino-compatible to the Internet with this WiFi shield that features the FCC-certified ATWINC1500 module from Atmel. Adafruit 3654
ArduCAM CC3200 UNO Board CC3200 UNO is full featured development board almost like a combination of CC3200 Launchpad plus CC3200CAMBOOST pack from TI while keeping exactly the same size as Arduino UNO and pin out. B0078
ESP8266 based Arduino board for ArduCAM mini camera modules while keeping the same form of factors and pinout as the standard Arduino UNO R3 board. ArduCAM B0082
Development board D1 Mini with WiFi module ESP-8266MOD and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini
IoT DFRobot Gravity UART OBLOQ module for working with Microsoft Azure. DFRobot TEL0118
Development board D1 Mini V3 with WiFi module ESP-8266 and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini V3
Development board with dimensions and spacing compatible with Arduino Uno R3. It have built-in Wi-Fi ESP8266 module. The device is compatible with WeDOS D1, it can be programmed from the level of Arduino IDE
Low power Wi-Fi module integrating wireless LAN and Cortex-M4 STM32F411CE microcontroller. It has 2 MB external flash memory, 512 KB bytes embedded flash memory, 128 KB RAM and peripherals. Seeed Studio 113990108
WiFI 802.11 b/g/n module. Equipment includes, among others: LED diode, antenna, 8 pins with 2.54mm pitch (including 3 GPIO lines). Power supply: 3.3V.
Wi-Fi module based on the ESP8266 system - simplicity of use (communication through UART, supports AT commands), 3.3V power supply, support for WPA / WPA2 encryption - these features make the EPS8266 module applicable anywhere, where reliable and effective data transmission. The module is not equipped with an antenna, it should be attached using the U.FL...
WiFi 802.11 b/g/n module with ESP8266 system, 16 terminals are available with a 2 mm pitch with the possibility of soldering gold pins, there are 9 GPIO lines and 1 ADC line on the connector. Built-in ceramic antenna and U.FL antenna connector. ESP-07