ESP-12E - WiFi module with ESP8266 and PCB antenna
ID: 557801
5906623454808
zł9.25
Tax included
zł7.52 tax excl.
WiFi 802.11 b/g/n module with ESP8266 system, they have 22 edge terminals with 2 mm raster with the possibility of soldered gold connectors, 9 GPIO lines and 1 ADC line on the connector. Built-in PCB antenna. ESP-12E
Description
WiFi 802.11 b/g/n module with ESP8266 system, they have 22 edge terminals with 2 mm raster with the possibility of soldered gold connectors, 9 GPIO lines and 1 ADC line on the connector. Built-in PCB antenna.
Attention!
Entering the EN 3.3 V line and GND line on the GPIO15 line starts the module software update mode.Distribution of signal lines:
- TXD0 / RXD0 - UART interface lines
- GND - mass
- VCC - 3.3V power supply
- EN - Power down line, after connecting the GND module goes into sleep mode.
- ADC - ADC line
- RST - Reset
- GPIOx - GPIO module lines
Features
- Module with ESP8266 system
- Supply voltage: 3.3V
- Frequency: 2.4 GHz
- Transmitted power level: +25 dBm
- It has a microstrip antenna
- WiFi standard - 802.11 b/g/n
- Connections: 9 GPIO ports, 1 ADC port, UART
- Interface :UART
- Supply voltage: 3.3V
- Dimensions: 24 x 16 [mm]
557801
Data sheet
- Logic voltage
- 3,3 V
- Wi-Fi chip
- ESP8266
- Wi-Fi standard
- 802.11 b/g/n
- Frequency range
- 2,4 GHz
- Baud rate
- 72,2 Mbps
- Antenna connector
- uFL
- Power supply voltage
- 3,3 V
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
WiFI 802.11 b/g/n module. Equipment includes, among others: LED diode, antenna, 8 pins with 2.54mm pitch (including 3 GPIO lines). Power supply: 3.3V.
zł10.41
24h
Available quantity: 80
Available
WiFi 802.11 b/g/n module with ESP8266 system, 16 terminals are available with a 2 mm pitch with the possibility of soldering gold pins, there are 9 GPIO lines and 1 ADC line on the connector. Built-in ceramic antenna and U.FL antenna connector. ESP-07
zł11.50
24h
Available quantity: 69
Available
WiFi module based on ESP8266. The module has a built-in antenna and USB-UART converter. The module can be programmed in Lua (under the control of the NodeMCU firmware) or in the Arduino environment. 10 GPIO lines are available which each can be configured to work as PWM, I2C.
zł19.48
24h
Available quantity: 30
Available
Development board with dimensions and spacing compatible with Arduino Uno R3. It have built-in Wi-Fi ESP8266 module. The device is compatible with WeDOS D1, it can be programmed from the level of Arduino IDE
zł25.31
24h
Available quantity: 11
Available
ZL5USB is a USB-UART converter module based on Silabs CP2102. The module has small sizes, microUSB connector and it can works with the 2.5...5.5V signals.
zł24.90
24h
Available quantity: 316
Available
Other products in the same category (16)
E-Paper ESP8266 Driver Board is a universal driver board for e-Paper displays. The board is based on the WiFi ESP8266 module. e-Paper ESP8266 Driver Board
zł53.96
24h
Available quantity: 3
Available
The IoT module combining Wi-Fi and Bluetooth (BLE) technologies, which is designed for a wide range of applications, from low-power sensor networks to the most demanding tasks such as voice coding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32D 128MBit
zł32.90
1 weeks
No product available!
A small evaluation board with nRF52840 (ARM Cortex-M4) and WiFi ESP32-D0WD module for projects related to Mesh networks. Adafruit 3997
zł256.95
24h
Available quantity: 2
Available
Module from the ESP32 series, combining a powerful microcontroller, Wi-Fi and Bluetooth 4.2 BLE. ESP-WROVER-B has a built-in PCB antenna, a large number of GPIO lines and small dimensions. Adafruit 3979
zł55.12
4 weeks
No product available!
Development board D1 Mini with WiFi module ESP-8266MOD and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini
zł18.24
24h
Available quantity: 54
Available
Development board D1 Mini V3 with WiFi module ESP-8266 and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini V3.x
zł18.70
24h
Available quantity: 25
Available
WiFi module developed by AI-Thinker Co., Ltd with ESP8266 processor. Integrates a 32-bit MCU microcontroller with 80 MHz clock, RTOS support, Wi-Fi and antenna. The module supports the IEEE802.11 b / g / ni standard and has a complete TCP / IP protocol stack. AI-Thinker ESP-12S
zł9.29
24h
Available quantity: 35
Available
Transceiver module equipped with SoC ESP8285 IoT enabling communication with WiFi networks. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 113020011
zł71.75
24h
Available quantity: 1
Available
Development kit designed to support rapid prototyping and knowledge of Azure Sphere technology. Seeed Studio 102991099
zł490.84
24h
Available quantity: 3
Available
Board for applications in the area of the Internet of Things (IoT). The module is based on the ESP-WROOM-32E system with 240 MHz clock, equipped with 4 MB Flash and 520 KB SRAM, as well as WiFi and Bluetooth communication. DFRobot DFR0654
zł48.89
24h
Available quantity: 9
Available
Board for applications in the area of the Internet of Things (IoT). The module is based on the ESP-WROOM-32E system with 240 MHz clock, equipped with 4 MB Flash and 520 KB SRAM, as well as WiFi and Bluetooth communication. DFrobot DFR0654-F
zł53.96
24h
Available quantity: 3
Available
A small WiFi module designed for IoT applications. It can communicate with the motherboard via the I2C or UART interface. DFRobot TEL126
zł78.93
24h
Available quantity: 1
Available
The Wio RP2040 module is an advanced Wi-Fi chip designed for IoT projects. Equipped with a powerful Raspberry Pi RP2040 processor and an ESP8285 Wi-Fi chip, it provides stable wireless connectivity. It is compatible with popular programming environments such as C/C++ and MicroPython. SeeedStudio 102991556
zł43.98
24h
Available quantity: 3
Available
Powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32E 32MBit (4MB)
zł19.08
24h
Available quantity: 8
Available
The expansion board (shield) with the DA16200 WiFi module. It is equipped with a Qwiic connector and is an excellent solution for IoT projects. SparkFun WRL-18567
zł105.42
24h
Available quantity: 2
Available
Function module designed for MicroMod boards. It allows you to add WiFi wireless communication based on the DA16200 chip to the project. SparkFun WRL-18594
zł161.66
24h
Available quantity: 1
Available
WiFi 802.11 b/g/n module with ESP8266 system, they have 22 edge terminals with 2 mm raster with the possibility of soldered gold connectors, 9 GPIO lines and 1 ADC line on the connector. Built-in PCB antenna. ESP-12E