CC3200-LAUNCHXL

Wi-Fi module based on the ESP8266 system - simplicity of use (communication through UART, supports AT commands), 3.3V power supply, support for WPA / WPA2 encryption - these features make the EPS8266 module applicable anywhere, where reliable and effective data transmission. The module is not equipped with an antenna, it should be attached using the U.FL connector. ESP-05

WiFi 2.4 GHz, IEEE Std. 802.11b RF Transceiver Module, Integrated PCB Antenna, Microchip , RoHS

Certified Wi-Fi solution especially designed for customers who want to migrate their existing 802.15.4 architecture to a standard TCP/IP based platform without having to redesign their existing hardware. WRL-10822

Module with Wi-Fi connectivity designed for Flipper Zero. It uses the ESP32-S2 chip and enables wireless firmware updates and advanced debugging via USB or Wi-Fi. Flipper Zero Wifi Devboard

WiFi 802.11 b/g/n module with ESP8266 system, they have 22 edge terminals with 2 mm raster with the possibility of soldered gold connectors, 9 GPIO lines and 1 ADC line on the connector. Built-in PCB antenna. ESP-12E

A small evaluation board with nRF52840 (ARM Cortex-M4) and WiFi ESP32-D0WD module for projects related to Mesh networks. Adafruit 3997

A WiFi overlay designed for the OpenMV camera that adds wireless internet connectivity. It is equipped with an ATWINC1500 WiFi module. SparkFun WRL-16776

With an integrated ESP8266 WiFi controller this module is a one-stop shop for almost any Internet-connected project. Firmware can be developed in Arduino and uploaded over a simple, serial interface. WRL-13711

WiFi module developed by AI-Thinker Co., Ltd with ESP8266 processor. Integrates a 32-bit MCU microcontroller with 80 MHz clock, RTOS support, Wi-Fi and antenna. The module supports the IEEE802.11 b / g / ni standard and has a complete TCP / IP protocol stack. AI-Thinker ESP-12S

Low power Wi-Fi module integrating wireless LAN and Cortex-M4 STM32F411CE microcontroller. It has 2 MB external flash memory, 512 KB bytes embedded flash memory, 128 KB RAM and peripherals. Seeed Studio 113990108

E-Paper ESP8266 Driver Board is a universal driver board for e-Paper displays. The board is based on the WiFi ESP8266 module. e-Paper ESP8266 Driver Board

WiFi module based on ESP8266. The module has a built-in antenna and USB-UART converter. The module can be programmed in Lua (under the control of the NodeMCU firmware) or in the Arduino environment. 10 GPIO lines are available which each can be configured to work as PWM, I2C.

Development board in Feather format equipped with AW-CU488. The module has an integrated WiFi wireless communication controller, LiPo charging circuit and Qwiic connector. SparkFun DEV-19957

High-Flying WiFi module, IEEE802.11b / g / n, with integrated PCB antenna, RoHS. HF-LPB100-1

Industrial RS232/485 converter for Ethernet and WiFi. It is equipped with a PoE function and is mounted on a DIN rail. Supports Modbus and MQTT protocols. Waveshare RS232 RS485 TO POE ETH (B)

WiFi 802.11 b/g/n module with ESP8266 system, 16 terminals are available with a 2 mm pitch with the possibility of soldering gold pins, there are 9 GPIO lines and 1 ADC line on the connector. Built-in ceramic antenna and U.FL antenna connector. ESP-07