New products
New products
Category: Light and color sensors
There are 82 products.
KAmodVL6180X is a module that allows to measure light intensity (ALS), distance to the object and recognition of gesture. It has an embedded voltage regulator and voltage level translators on signal lines. Thanks to this can be used in systems with 2.8...5.5V power supply voltage.
The module allows measuring the light around the sensor. The measuring range is in the range 1 - 65535 LUX, and communication takes place using the I2C bus. modBH1750 (GY-302)
Module with an analog TEMT6000 light intensity sensor. The output voltage increases with the intensity of the incident light. The sensor is powered with the voltage of 5 V
Light sensor module in the form of a photoresistor. A comparator and a potentiometer are placed on the board. The module has a digital output
Module with an analog TEMT6000 light intensity sensor. The output voltage is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V
Module with light sensor (photoresistor). An analog output was led out on the XH2.54 connector
modTSL2561 is a module containing a light sensor TSL2561; communication with the system takes place using the I2C bus
A module with a light sensor in the form of a photoresistor. There is a comparator and a potentiometer on the board. The module has a digital output
SEN0162 This UV Sensor with GUVA-S12SD chip is suitable for detecting the UV raditation in sunlight. It can be used in UV Index Monitoring, DIY project, UV-A Lamp Monitoring, Plants growing Environmental monitoring...etc.
Grove module with a proximity sensor, light, color and the ability to detect gestures. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 101020580
Great way to upgrade a project that uses a photocell and needs RoHS compliance. Due to the high rejection ratio of infrared radiation, the spectral response of the ambient light sensor is close to that of human eyes. Adafruit 2748
Module with color sensor TCS3472. The board is equipped with a Grove connector and communicates via the I2C interface. M5Stack U009
Module with analogue UV light sensor ML8511. It enables the measurement of the radiation intensity for the UV-A (320-400nm) and UV-B (280-320nm) waves. It has an analog interface. GY8511
Module with three optical inspection sensors (spectrophotometers) from the AS7265x series. The module consists of three sensors; AS72651, AS72652 and AS72653 which can detect wavelengths from 410nm (UV) to 940nm (IR). SparkFun SEN-15050
Module with color sensor TCS34725FN. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020341
TCS34725 RGB Color Sensor is a color sensor TCS34725 controlled by the I2C interface. It is powered by voltage in the range of 3.3 ... 5V and is intended for Arduino-compatible boards. DFRobot SEN0212
Module with TCS3200D system - sensor of RGB light components
Ambient light sensor placed in a transparent hemisphere. It supports a detection range of 0 to 200 klx and communicates via the I2C interface. DFRobot SEN0390