New products
New products New products
Available
zł73.14
24h
Available
zł1,049.01
24h
Available
Fermion: BH1750 Light Sensor
ID: 584951
5906623434152
zł30.95
Tax included
zł25.16 tax excl.
The module allows the measurement of lighting in the vicinity of the sensor. The measuring range is from 1 to 65535 LUX, and communication takes place using the I2C bus. DFRobot SEN0097
Description
Module with light sensor BH1750. It has a built-in 16-bit ADC converter, thanks to which the user receives a digital signal and measurement expressed in lux, which avoids additional conversions. It is a good replacement for photoresistors, offering greater accuracy and easier implementation in the application. The module communicates via the I2C interface. Full documentation is available on the product Wiki page.
Features
- Wide range and high measurement resolution (1 to 65535 lux)
- Interface; I2C
- A spectral response similar to that of the human eye
- Implementation of the brightness converter function -> digital signal
- Low-power mode
- Noise filtering function (50Hz / 60Hz)
- Small variation in measurements (+/- 20%)
- Insignificant influence of infrared lighting on the sensor results
- Supply voltage: 3 to 5V
- Dimensions: 21 x 16 mm
Kit contains
- Fermion module: BH1750 Light Sensor
- Straight 5-pin connector
584951
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Cables for evaluation boards, set of 10 pcs., blue colour
zł5.20
24h
Available quantity: 199
Available
Cables for evaluation boards, set of 10 pcs., red colour
zł5.20
24h
Available quantity: 240
Available
Cables for evaluation boards, set of 10 pcs., green colour
zł5.46
24h
Available quantity: 349
Available
Cables for evaluation boards, set of 10 pcs., yellow colour
zł5.61
24h
Available quantity: 55
Available
A set of 40 female-female connection cables, in various colors, 17 cm long. CAB_F-F (Rainbow-40-17)
zł5.69
24h
Available quantity: 789
Available
10 DoF module with ADXL345 accelerometer, HMC5883L magnetometer, ITG-3205 gyroscope and BMP280 barometer. Communication via the I2C interface. DFRobot SEN0140
zł60.58
24h
Available quantity: 1
Available
Module with 11-channel AS7341 sensor that allows to detect light in different wavelength ranges (color detection). It communicates via the I2C interface. DFRobot SEN0365
zł92.89
24h
Available quantity: 1
Available
Other products in the same category (16)
Precise solar radiation intensity sensor in the range from 400 to 1100 nm, communicating via Modbus-RTU (RS485) and resistant to harsh conditions thanks to the aluminum housing class IP67. High accuracy (±5%), fast response time (≤10 s) and resistance to dirt make it ideal for monitoring photovoltaics, environmental research and meteorology. DFRobot SEN0640
zł278.95
4 weeks
No product available!
Module with an analog TEMT6000 light intensity sensor. The output voltage is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V
zł13.38
24h
Available quantity: 13
Available
Module with a light intensity sensor BH1750FVI dedicated to the M5StickC sets. It communicates via the I2C interface. M5Stack U134
zł27.90
24h
Available quantity: 1
Available
Module with analogue UV light sensor ML8511. It enables the measurement of the radiation intensity for the UV-A (320-400nm) and UV-B (280-320nm) waves. It has an analog interface. GY8511
zł89.97
4 weeks
No product available!
Module with an analog TEMT6000 light intensity sensor. The voltage at the output is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V. DFRobot SEN0043
zł30.53
24h
Available quantity: 2
Available
Sensor for detecting the distance, intensity and frequency of lightning within a radius of 40 km. The module enables weather enthusiasts to measure local storm data. SparkFun SEN-15441
zł135.85
3 weeks
No product available!
Module with light sensor - LS06-S phototransistor. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020173
zł21.99
24h
Available quantity: 3
Available
Module with a SI1145 light sensor that can detect waves with a wide range of wavelengths: UV, visible and infrared light. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020089
zł54.75
24h
Available quantity: 5
Available
Module with environmental sensors for Raspberry Pi Pico. It allows you to measure temperature, humidity, air quality pressure and color detection. SB Components 22366
zł208.80
24h
Available quantity: 3
Available
Module with light sensor - LS06-S phototransistor. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020132
zł10.22
24h
Available quantity: 3
Available
Gravity: High Accuracy is a multifunctional environmental sensor with Gravity I2C and UART output. Perfect for weather station projects. DFRobot SEN0501
zł136.36
24h
Available quantity: 1
Available
Light sensor module in the form of a photoresistor. A comparator and a potentiometer are placed on the board. The module has a digital output
zł5.71
24h
Available quantity: 6
Available
Compact light sensor that provides precise measurement of both illuminance (10–10000 Lux) and correlated color temperature (2700K–6500K), with low measurement errors. Thanks to I2C and UART interfaces, the sensor easily integrates with platforms such as Arduino or Raspberry Pi, making it an ideal tool for photographers, filmmakers and projects requiring lighting control. DFRobot SEN0611
zł145.44
4 weeks
No product available!
No product available!
The module allows measuring the light around the sensor. The measuring range is in the range 1 - 65535 LUX, and communication takes place using the I2C bus. modBH1750 (GY-302)
zł7.81
24h
Available quantity: 19
Available
Module with light sensor VEML7700. It allows you to measure the intensity in the range from 0 to 120 Klx. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5378
zł24.62
24h
Available quantity: 4
Available
The module allows the measurement of lighting in the vicinity of the sensor. The measuring range is from 1 to 65535 LUX, and communication takes place using the I2C bus. DFRobot SEN0097