Flame sensor - Grove module

Color sensor with a range from 8 to 16 mm. It offers 3 operating modes and can be powered with the voltage from 12 to 24 V. DFRobot SEN0506

Module with a UV light sensor LTR390-UV. It allows you to measure the intensity of ultraviolet radiation and visible light. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4831

Module with a 10-channel AS7341 sensor that detects light in various wavelength ranges (color detection). It communicates via the I2C interface. Adafruit 4698

A module with a light sensor in the form of a photoresistor. There is a comparator and a potentiometer on the board. The module has a digital output

Module with an analog TEMT6000 light intensity sensor. The output voltage increases with the intensity of the incident light. The sensor is powered with the voltage of 5 V

Great way to upgrade a project that uses a photocell and needs RoHS compliance. Due to the high rejection ratio of infrared radiation, the spectral response of the ambient light sensor is close to that of human eyes. Adafruit 2748

SEN0162 This UV Sensor with GUVA-S12SD chip is suitable for detecting the UV raditation in sunlight. It can be used in UV Index Monitoring, DIY project, UV-A Lamp Monitoring, Plants growing Environmental monitoring...etc.

Module with digital light intensity sensor MAX44009. It is supplied with the voltage from 1.7 to 3.6 V and communicates via the I2C interface. GY-49

The module allows measuring the light around the sensor. The measuring range is in the range 1 - 65535 LUX, and communication takes place using the I2C bus. modBH1750 (GY-302)

Color sensor equipped with the OPT4048 sensor from Texas Instruments. It allows you to determine the characteristics of ambient light by measuring parameters such as light intensity, color in the CIE XY, LUV coordinate systems, as well as color temperature. The module is equipped with Qwiic connectors. SparkFun SEN-22638

TCS34725 RGB Color Sensor is a color sensor TCS34725 controlled by the I2C interface. It is powered by voltage in the range of 3.3 ... 5V and is intended for Arduino-compatible boards. DFRobot SEN0212

modTSL2561 is a module containing a light sensor TSL2561; communication with the system takes place using the I2C bus

Color Sensor Module, TCS3200, LEDs, RoHs

Module with a light intensity sensor BH1750. The measuring range is from 1 to 65535 lux, and communication is carried out using the I2C bus. Adafruit 4681

UV Sensor with response spectrum: 200nm-370nm

Module with analogue UV light sensor ML8511. It enables the measurement of the radiation intensity for the UV-A (320-400nm) and UV-B (280-320nm) waves. It has an analog interface. GY8511