Category: Intelligent clothes
Subcategories
There are 34 products.
Pressure-Sensitive Conductive Sheet. Adafruit 1361
Woven conductive fabric silver-plated nylon with resistance of less than 1 ohm per foot in any direction across the textile. Great for use with FLORA. 20 cm x 20 cm piece. Adafruit 1168
Knit conductive 100% silver fabric with resistance of less than 1 ohm per foot in any direction across the textile. Great for use with FLORA. 20 cm x 20 cm piece. Adafruit 1167
Adafruit 603 - Stainless Thin Conductive Yarn / Thick Conductive Thread - 35 ft
Ambient Light Sensor, SI1145, connects to the I2C bus pads. Adafruit 1981
Adafruit 1088
TCS34725 has RGB and Clear light sensing elements. An IR blocking filter, integrated on-chip and localized to the color sensing photodiodes, minimizes the IR spectral component of the incoming light and allows color measurements to be made accurately. Adafruit 1356
Power module designed to work with LilyPad boards. It is equipped with a switch and a CR2032 battery socket. SparkFun DEV-13883
FLORA is Adafruit\'s fully-featured wearable electronics platform. It\'s a round, sewable, Arduino-compatible microcontroller designed to empower amazing wearables projects. Adafruit 659
DEV-10867 - Conductive Thread Bobbin - 30ft (Stainless Steel)
Adafruit 519 - Conductive Rubber Cord Stretch Sensor + extras!
This is the second version of the Flora NeoPixels, which runs at at \'high speed\' 800KHz communication. Adafruit 1260
Adafruit 1126 - Sewable Snaps - 5mm Diameter - Card of 24
The LilyPad series module is designed for prototyping interactive e-textiles. It consists of a board with a SAMD11 microcontroller and a CR2032 battery socket, LEDs, a light sensor and a button. SparkFun DEV-14063
This knit jersey conductive fabric is 63% cotton, 35% silver yarn and 2% spandex. Use small pieces for soft switches, plush keypads, capacitive touch sensors, and other textile interfaces. Adafruit 1364
A miniature module with a programmed AVR Attiny85 microcontroller, equipped with 8 KB of Flash memory, 4 digital pins, analog input and 2 PWM channels. By connecting the LEDs to the digital outputs of the module, interesting lighting effects can be obtained. SparkFun DEV-10899
Kit with LEDs, battery, needles and conductive thread that allows you to sew LED lighting into clothes. SparkFun DEV-11590
Adafruit 1059 - Flora Wearable Ultimate GPS Module