Electro-Fashion LED Board - LED module (white) - 10 pcs.

Adafruit 1222

A miniature module with a LiPo battery charger with a capacity of 500 mA. SparkFun DEV-11893

Microcontroller board controlled by ATmega32U4 with Arduino bootloader. Due to the dimensions and openings, it is perfect for electronic components sewn into clothes. It has a built-in JST connector with a charging circuit and a switch and is programmed via a micro USB connector. SparkFun DEV-12049

The Flora budget starter kit contains everything you need to start an adventure with smart clothing. Included, among others motherboard, LED diodes, conductive cord, battery basket. Adafruit 1405

TCS34725 has RGB and Clear light sensing elements. An IR blocking filter, integrated on-chip and localized to the color sensing photodiodes, minimizes the IR spectral component of the incoming light and allows color measurements to be made accurately. Adafruit 1356

This module allows you to automatically turn on LEDs in the dark thanks to a built-in light sensor. It comes with a CR2032 battery holder and a slide switch to turn the module on and off. It also has two sets of pads for connecting LEDs, allowing for flexible lighting design. Kitronik 2721

A miniature module with a programmed AVR Attiny85 microcontroller, equipped with 8 KB of Flash memory, 4 digital pins, analog input and 2 PWM channels. By connecting the LEDs to the digital outputs of the module, interesting lighting effects can be obtained. SparkFun DEV-10899

A set of 20 modules with RGB diodes with a diameter of 12.5 mm. The diodes have a 24-bit range of colors. Adafruit 1559

A switch for e-textile projects that allows you to easily turn circuits on and off with a single click. Thanks to its latching mechanism, it works like a typical switch – one press turns on the power, and another cuts it off. Equipped with large "IN" and "OUT" contact pads, it allows for convenient sewing of conductive thread and quick connection of components such as LEDs or buzzers. Kitronik 2753

Button cell battery holder specially designed for e-textiles from Kitronik. It has large connection points that allow easy connection of the conductive thread. Dedicated to CR2032 batteries. Kitronik 2711

GEMMA M0 is an intelligent clothing controller from Adafruit. In relation to the classic GEMMA board, it was equipped with a 32-bit ATSAMD21E18 microcontroller (based on Cortex M0 +). It has GPIO pins, RGB DotStar diode. The board can be powered by a 3.7 V Li-Ion battery (JST connector). Adafruit 3501

DEV-23903

The LilyPad series module is designed for prototyping interactive e-textiles. It consists of a board with a SAMD11 microcontroller and a CR2032 battery socket, LEDs, a light sensor and a button. SparkFun DEV-14063

Microcontroller board controlled by ATmega32U4 with Arduino bootloader. Due to its dimensions and holes, it will be excellent for electronic components sewn into clothing. It has a built-in JST connector with charging circuit and on/off switch and is programmable via micro USB. SparkFun DEV-14631

This is the second version of the Flora NeoPixels, which runs at at \'high speed\' 800KHz communication. Adafruit 1260

Adafruit 1059 - Flora Wearable Ultimate GPS Module