Electro-Fashion Coin Cell Holder - CR2032 battery slot

This module allows you to automatically turn on LEDs in the dark thanks to a built-in light sensor. It comes with a CR2032 battery holder and a slide switch to turn the module on and off. It also has two sets of pads for connecting LEDs, allowing for flexible lighting design. Kitronik 2721

This is the second version of the Flora NeoPixels, which runs at at \'high speed\' 800KHz communication. Adafruit 1260

A compact light sensor for e-textile projects that allows devices to be activated based on ambient light levels. The OUT output generates a voltage ranging from 0.9V in low light to 2.9V in bright environments, allowing for the creation of interactive effects in clothing and accessories. Large connection points allow for easy sewing of conductive thread, and the small size makes the module easy to integrate into a variety of projects. Kitronik 2754

DEV-13342

Kitronik 2752 is a sewable coin cell battery holder with a built-in latching switch, designed for e-textile projects. It enables easy powering of electronic circuits in clothing and allows users to control their operation using the integrated switch.

Adafruit 1222

Slim 3V battery powered LEDs that are perfect for e-textile projects. With clearly marked connectors and double-sided PCB, these LEDs are easy to connect and highly durable, making them the perfect choice for interactive clothing, accessories and decorations that combine fashion with modern technology. Kitronik 2714

A miniature module with a LiPo battery charger with a capacity of 500 mA. SparkFun DEV-11893

A switch for e-textile projects that allows you to easily turn circuits on and off with a single click. Thanks to its latching mechanism, it works like a typical switch – one press turns on the power, and another cuts it off. Equipped with large "IN" and "OUT" contact pads, it allows for convenient sewing of conductive thread and quick connection of components such as LEDs or buzzers. Kitronik 2753

A set of 20 modules with RGB diodes with a diameter of 12.5 mm. The diodes have a 24-bit range of colors. Adafruit 1559

The Flora budget starter kit contains everything you need to start an adventure with smart clothing. Included, among others motherboard, LED diodes, conductive cord, battery basket. Adafruit 1405

Sewable with a 3-pin JST wiring adapter with 3 holes on the board perfect for conductive thread or soldering, wired to a single 3-pin JST-PH Adapter. Sdafruit 2566

GEMMA M0 is an intelligent clothing controller from Adafruit. In relation to the classic GEMMA board, it was equipped with a 32-bit ATSAMD21E18 microcontroller (based on Cortex M0 +). It has GPIO pins, RGB DotStar diode. The board can be powered by a 3.7 V Li-Ion battery (JST connector). Adafruit 3501

Power module designed to work with LilyPad boards. It is equipped with a switch and a CR2032 battery socket. SparkFun DEV-13883

A motion-activated module that activates the circuit when tilted 10° from the horizontal position. Equipped with double-sided connection points for conductive thread, it can be easily incorporated into clothing, bags, or interactive decorations. The module supports voltages up to 24 V and a maximum current of 25 mA, and its compact size makes it convenient for small e-textile projects. Kitronik 2710

The Flora starter kit contains everything you need to start an adventure with smart clothing. Included, among others main board, GPS module, LED diodes, conductive cord, battery basket. Adafruit 1090