LilyPad Coin Cell Battery Holder - module with a CR2032 battery socket

The Flora starter kit contains everything you need to start an adventure with smart clothing. Included, among others main board, GPS module, LED diodes, conductive cord, battery basket. Adafruit 1090

DEV-13342

Kit with LEDs, battery, needles and conductive thread that allows you to sew LED lighting into clothes. SparkFun DEV-11590

A set of 20 modules with RGB diodes with a diameter of 12.5 mm. The diodes have a 24-bit range of colors. Adafruit 1559

Adafruit 1222

Microcontroller board controlled by ATmega32U4 with Arduino bootloader. Due to its dimensions and holes, it will be excellent for electronic components sewn into clothing. It has a built-in JST connector with charging circuit and on/off switch and is programmable via micro USB. SparkFun DEV-14631

The LilyPad series module is designed for prototyping interactive e-textiles. It consists of a board with a SAMD11 microcontroller and a CR2032 battery socket, LEDs, a light sensor and a button. SparkFun DEV-14063

Sewable with a 3-pin JST wiring adapter with 3 holes on the board perfect for conductive thread or soldering, wired to a single 3-pin JST-PH Adapter. Sdafruit 2566

Button cell battery holder specially designed for e-textiles from Kitronik. It has large connection points that allow easy connection of the conductive thread. Dedicated to CR2032 batteries. Kitronik 2711

The Flora budget starter kit contains everything you need to start an adventure with smart clothing. Included, among others motherboard, LED diodes, conductive cord, battery basket. Adafruit 1405

TCS34725 has RGB and Clear light sensing elements. An IR blocking filter, integrated on-chip and localized to the color sensing photodiodes, minimizes the IR spectral component of the incoming light and allows color measurements to be made accurately. Adafruit 1356

A miniature module with a LiPo battery charger with a capacity of 500 mA. SparkFun DEV-11893

Adafruit 1059 - Flora Wearable Ultimate GPS Module

GEMMA M0 is an intelligent clothing controller from Adafruit. In relation to the classic GEMMA board, it was equipped with a 32-bit ATSAMD21E18 microcontroller (based on Cortex M0 +). It has GPIO pins, RGB DotStar diode. The board can be powered by a 3.7 V Li-Ion battery (JST connector). Adafruit 3501

XBee adapter with pads with holes for sewing the module to clothes and fabrics. SparkFun DEV-12921

DEV-23903