LilyPad XBee - XBee adapter

The Flora budget starter kit contains everything you need to start an adventure with smart clothing. Included, among others motherboard, LED diodes, conductive cord, battery basket. Adafruit 1405

Microcontroller board controlled by ATmega32U4 with Arduino bootloader. Due to its dimensions and holes, it will be excellent for electronic components sewn into clothing. It has a built-in JST connector with charging circuit and on/off switch and is programmable via micro USB. SparkFun DEV-14631

A switch for e-textile projects that allows you to easily turn circuits on and off with a single click. Thanks to its latching mechanism, it works like a typical switch – one press turns on the power, and another cuts it off. Equipped with large "IN" and "OUT" contact pads, it allows for convenient sewing of conductive thread and quick connection of components such as LEDs or buzzers. Kitronik 2753

This module allows you to automatically turn on LEDs in the dark thanks to a built-in light sensor. It comes with a CR2032 battery holder and a slide switch to turn the module on and off. It also has two sets of pads for connecting LEDs, allowing for flexible lighting design. Kitronik 2721

This is the second version of the Flora NeoPixels, which runs at at \'high speed\' 800KHz communication. Adafruit 1260

Kit with LEDs, battery, needles and conductive thread that allows you to sew LED lighting into clothes. SparkFun DEV-11590

TCS34725 has RGB and Clear light sensing elements. An IR blocking filter, integrated on-chip and localized to the color sensing photodiodes, minimizes the IR spectral component of the incoming light and allows color measurements to be made accurately. Adafruit 1356

Adafruit 1222

DEV-13342

The Flora starter kit contains everything you need to start an adventure with smart clothing. Included, among others main board, GPS module, LED diodes, conductive cord, battery basket. Adafruit 1090

Slim 3V battery powered LEDs that are perfect for e-textile projects. With clearly marked connectors and double-sided PCB, these LEDs are easy to connect and highly durable, making them the perfect choice for interactive clothing, accessories and decorations that combine fashion with modern technology. Kitronik 2714

Microcontroller board controlled by ATmega32U4 with Arduino bootloader. Due to the dimensions and openings, it is perfect for electronic components sewn into clothes. It has a built-in JST connector with a charging circuit and a switch and is programmed via a micro USB connector. SparkFun DEV-12049

GEMMA M0 is an intelligent clothing controller from Adafruit. In relation to the classic GEMMA board, it was equipped with a 32-bit ATSAMD21E18 microcontroller (based on Cortex M0 +). It has GPIO pins, RGB DotStar diode. The board can be powered by a 3.7 V Li-Ion battery (JST connector). Adafruit 3501

A miniature module with a programmed AVR Attiny85 microcontroller, equipped with 8 KB of Flash memory, 4 digital pins, analog input and 2 PWM channels. By connecting the LEDs to the digital outputs of the module, interesting lighting effects can be obtained. SparkFun DEV-10899

A motion-activated module that activates the circuit when tilted 10° from the horizontal position. Equipped with double-sided connection points for conductive thread, it can be easily incorporated into clothing, bags, or interactive decorations. The module supports voltages up to 24 V and a maximum current of 25 mA, and its compact size makes it convenient for small e-textile projects. Kitronik 2710

Sewable with a 3-pin JST wiring adapter with 3 holes on the board perfect for conductive thread or soldering, wired to a single 3-pin JST-PH Adapter. Sdafruit 2566