FLORA Budget Pack - Flora starter kit

GEMMA M0 is an intelligent clothing controller from Adafruit. In relation to the classic GEMMA board, it was equipped with a 32-bit ATSAMD21E18 microcontroller (based on Cortex M0 +). It has GPIO pins, RGB DotStar diode. The board can be powered by a 3.7 V Li-Ion battery (JST connector). Adafruit 3501

TCS34725 has RGB and Clear light sensing elements. An IR blocking filter, integrated on-chip and localized to the color sensing photodiodes, minimizes the IR spectral component of the incoming light and allows color measurements to be made accurately. Adafruit 1356

A miniature module with a LiPo battery charger with a capacity of 500 mA. SparkFun DEV-11893

This module allows you to automatically turn on LEDs in the dark thanks to a built-in light sensor. It comes with a CR2032 battery holder and a slide switch to turn the module on and off. It also has two sets of pads for connecting LEDs, allowing for flexible lighting design. Kitronik 2721

A motion-activated module that activates the circuit when tilted 10° from the horizontal position. Equipped with double-sided connection points for conductive thread, it can be easily incorporated into clothing, bags, or interactive decorations. The module supports voltages up to 24 V and a maximum current of 25 mA, and its compact size makes it convenient for small e-textile projects. Kitronik 2710

Button cell battery holder specially designed for e-textiles from Kitronik. It has large connection points that allow easy connection of the conductive thread. Dedicated to CR2032 batteries. Kitronik 2711

XBee adapter with pads with holes for sewing the module to clothes and fabrics. SparkFun DEV-12921

Kitronik 2718 is a miniature sewable coin cell battery holder designed for e-textile projects, enabling easy power supply to electronic circuits in clothing. Thanks to its compact size and specially designed mounting holes, the holder can be easily sewn onto fabric, making it ideal for use in smart clothing and wearable accessories.

Microcontroller board controlled by ATmega32U4 with Arduino bootloader. Due to the dimensions and openings, it is perfect for electronic components sewn into clothes. It has a built-in JST connector with a charging circuit and a switch and is programmed via a micro USB connector. SparkFun DEV-12049

The Flora starter kit contains everything you need to start an adventure with smart clothing. Included, among others main board, GPS module, LED diodes, conductive cord, battery basket. Adafruit 1090

Kit with LEDs, battery, needles and conductive thread that allows you to sew LED lighting into clothes. SparkFun DEV-11590

A compact light sensor for e-textile projects that allows devices to be activated based on ambient light levels. The OUT output generates a voltage ranging from 0.9V in low light to 2.9V in bright environments, allowing for the creation of interactive effects in clothing and accessories. Large connection points allow for easy sewing of conductive thread, and the small size makes the module easy to integrate into a variety of projects. Kitronik 2754

Kitronik 2752 is a sewable coin cell battery holder with a built-in latching switch, designed for e-textile projects. It enables easy powering of electronic circuits in clothing and allows users to control their operation using the integrated switch.

DEV-13342

Button cell battery socket specially designed for e-textiles from Kitronik. It has large connection points that allow easy connection of the conductive thread. Dedicated to CR2032 batteries. Kitronik 2701

Sewable with a 3-pin JST wiring adapter with 3 holes on the board perfect for conductive thread or soldering, wired to a single 3-pin JST-PH Adapter. Sdafruit 2566