Order and pay in
for same day shipping
JST-PH three-wire connection cable, 20 cm long, 2 mm grid
Bi-directional 8-channel logic level converter module (1.2-3.6V to...
ZeroPi is a FriendlyELEC single board computer with Allwinner H3 and...
Module with the MCP9600 amplifier designed to work with a K-type...
Heat shrink tube for electrical and mechanical insulation, diameter...
The MIMXRT1062DVL6A Processor Evaluation Kit, which runs up to 600 MHz,...
RTL8370N-VB-CG, high-performance 8-port Gigabit Ethernet switch, LQFP128
LT8911EXB, MIPI DSI/CSI Bridge to eDP, QFN48
V4 features the same sensors as v3 (L3GD20H, LSM303D) and adds an LPS25H digital barometer. An I²C interface accesses 10 independent measurements that can be used to calculate the sensor’s altitude and absolute orientation.
Inertial measurement unit (IMU) and altimeter that features the same LSM6DS33 gyro and accelerometer and LIS3MDL magnetometer as the MinIMU-9 v5, and adds an LPS25H digital barometer. Pololu 2739
Atmospheric pressure sensor module with altitude and temperature measurement function. It has the ability to program events and sampling frequency (in the range from 1s to 9h). The MPL3115A2 sensor is fully internally compensated. SparkFun SEN-11084
Precision sensor from Bosch for measuring humidity with ±3% accuracy, barometric pressure with ±1 hPa absolute accuraccy, and temperature with ±1.0°C accuracy Adafruit 2652
10DOF module with intelligent orientation sensor BNO055 (accelerometer, gyroscope and magnetometer + microcontroller) and BMP280 pressure sensor equipped with Gravity connector. DFRobot SEN0253
Water pressure sensor with 3-pin Gravity interface. It enables the measurement of liquid pressure in the range from 0 to 1.6 MPa. It is supplied with the voltage of 5 V and has a linear output voltage from 0.5 to 4.5 V. DFRobot SEN0257
Module with digital barometer BMP388. The system measures pressure in the range from 300 to 1250 hPa and temperature from -40 ℃ to 80 ℃. DFRobot SEN0251
BME280 integrates onboard temperature sensor, humidity sensor and barometer. It provides both SPI and I2C interfaces; and can be widely used in environmental monitoring, story height measurement and Internet of Things (IoT) control and so on. SEN0236
I2C BME680 Environmental Sensor is a gas, pressure, temperature and humidity sensor in one MEMS housing. The module is supplied with 3.3-5V, for communication the I2C or SPI interface is used. DFRobot SEN0248
The GY-BMP280 is an atmospheric pressure sensor module. It allows measurement in the range of 300 ... 1100 hPa with an accuracy of 1 hPa. The sensor uses I2C or SPI bus
Wireless, precise pressure, temperature and humidity sensor with built-in event memory mutex / ocfipreoqyfb / mutex
Wireless, precision, high accuracy pressure and temperature sensor with built-in event memory
Pressure sensor module with I2C interface (MPL115A2)
Pressure sensor module with I2C interface (BMP085)
KAmodLPS25HB is a module that allows the measurement of atmospheric pressure in the range of 260-1260hPa with a resolution of 0.01hPa, and thanks to the embedded regulator and voltage translator levels, it can be successfully used in systems supplied with a voltage of 2.5 - 5.5 V.