Gravity: Analog Water Pressure Sensor - analog water pressure sensor

Miniature pressure measurement module equipped with a 25 psi piezoresistive pressure sensor. It allows you to perform calibrated and compensated pressure measurements from 60 mbar to 2.5 bar. SparkFun SEN-16476

Multi-functional environmental sensor consisting of SHTC3 temperature and humidity sensor, BMP280 pressure sensor, VEML7700 ambient light sensor and ML8511 UV sensor. DFRobot SEN0500

Grove module with temperature, humidity and pressure sensor. The board is equipped with a Grove connector and communicates via I2C or SPI. Seeed Studio 101020193

LPS331AP Pressure/Altitude Sensor Carrier with Voltage Regulator

Crowtail – BME280 Atmospheric Sensor 2.0 is a multifunctional environmental sensor measuring temperature, humidity, and pressure, with an I2C interface and low power consumption. It is used in weather applications, home automation, and mobile systems.

LPS35HW waterproof barometer module. It can measure pressure from 260 to 1260 hPa and communicates via I2C or SPI. Adafruit 4258

The GY-BMP280 is an atmospheric pressure sensor module. It allows measurement in the range of 300 ... 1100 hPa with an accuracy of 1 hPa. The sensor uses I2C or SPI bus

KAmodLPS25HB is a module that allows the measurement of atmospheric pressure in the range of 260-1260hPa with a resolution of 0.01hPa, and thanks to the embedded regulator and voltage translator levels, it can be successfully used in systems supplied with a voltage of 2.5 - 5.5 V.

Module with pressure and temperature sensor BMP280. It allows you to read the atmospheric pressure in the range from 300 to 1100 hPa and communicates via the I2C or SPI interface. Adafruit 2651

Pressure sensor module with I2C interface (BMP085)

This precision barometric pressure and temperature sensor is ideal for environmental applications. Its low noise floor allows for detection of elevation changes down to approximately 1 cm and offers a relative accuracy of ±0.4 Pa. It supports I2C and SPI interfaces for easy integration with microcontrollers. The pre-assembled module includes a built-in 3.3V regulator, logic level conversion, and STEMMA QT connectors. Adafruit 6407

Module with sensors of environmental parameters. It allows you to measure temperature, humidity and pressure as well as CO2 and VOC concentration. DFRobot SEN0335

Crowtail – BMP180 Barometer is a digital pressure and temperature sensor with an I2C interface, intended for precise measurements in mobile and environmental systems. It offers high accuracy, low power consumption, and readiness to operate without additional calibration.

Module with a digital barometer DPS310. It enables pressure measurement in the range from 300 to 1200 hPa and communicates via I2C or SPI. Adafruit 4494

KAmod BMP390 contains a precise BMP390 sensor manufactured by Bosch Sensortec, enabling the measurement of atmospheric pressure and temperature. All key signals of the miniature BMP390 sensor are routed on the module board, facilitating its use in modular applications. Communication is carried out via SPI or I2C interfaces equipped with voltage level translation circuits.

Module with waterproof barometer and MS5837 temperature sensor. It enables pressure measurement in the range from 300 to 1200 hPa and communicates via I2C