Category: Components for 3D printers
There are 74 products.
Silicone pad with a working temperature of up to 200°C. Used to level tables in 3D printers as an alternative to a set of springs
Threaded pipe used to connect the heat sink and heating block, contains a Teflon tube in the middle, adapted to a 1.75 mm filament
Ceramic heater designed for installation in the heating block of a 3D printer. Power 50 W, powered by 12 V
Threaded pipe used to connect the heat sink and heating block, contains a Teflon tube in the middle, adapted to a 1.75 mm filament
PC4 Bowden mount with M6 thread on a 4 mm diameter tube (fits 1.75 mm filament). Used to connect PTFE tubes with an extruder in 3D printers
Cooling fan powered with the voltage of 5 V with a lead out a cable with a two-pin connector with a pitch of 2.54 mm
Ceramic heater designed for installation in the heating block of a 3D printer. Power 40 W, powered by 24 V
Eccentric spacer with an internal diameter of 5 mm. Allows adjustment of the roller pressure on V-Slot aluminium profiles in 3D printers or CNC machines.
Nut with M4 thread for screwing the table to the 3D printer
Eccentric spacer with an internal diameter of 5 mm. Allows adjustment of the roller pressure on V-Slot aluminium profiles in 3D printers or CNC machines.
Ceramic heater designed for installation in the heating block of a 3D printer. Power 40 W, powered by 12 V
Connector for fixing Teflon tubes in pneumatic systems. It is also used in 3D printing, where it is used to attach the filament supply tube to the print head
Bearing GT2 20T pulley for a shaft with a diameter of 5 mm. Without teeth, suitable for 6 mm wide belt
Aluminium heating block dedicated to V6 nozzles. Provides effective and even heating of the print nozzle
Bimetallic heatbreak dedicated to Ender 3
Connector for fixing Teflon tubes in pneumatic systems. It is also used in 3D printing, where it is used to attach the filament supply tube to the print head
Temperature sensor for 3D printer - 100K thermistor with 90 cm cables. It can be used to measure the temperature of the table and the head
Bearing GT2 pulley for shaft diameter 5 mm. It has 20 teeth, suitable for a 6mm wide belt
Ceramic heater designed for installation in the heating block of a 3D printer. Power 50 W, powered by 24 V
Bimetallic heatbreak dedicated to the Ender CR6 SE. Avoids clogging of the head