New products
New products
Category: Keyboards, buttons
There are 54 products.
KAmodPCF8883T is a module with capacitive touch sensor PCF8883 from NXP. The module has a probe placed on the PCB and a diode indicating the state of the chip. It enables work in one of three modes.
Module with AT42QT1060 controller - contectless keyboard controller, Kamami, RoHS.
Module with a button and a cover in red
Two-axis joystick with "ENTER" button, analogue output signal
Touch Sensor Switch Module for Arduino, RoHS
Keyboard module with 16 buttons in the form of a 4x4 matrix. Equipped with an 8-pin connector with 2.54 mm pitch
Membrane keypad module with 4 buttons. It is equipped with a tape terminated with a 5-pin connector
5-button keyboard module with analog output
Membrane keypad module with 12 (3x4) buttons. It is equipped with a tape terminated with a 7-pin connector
Switch module with an interlock. DFRobot DFR0423
Keyboard module with 10 tact switch buttons. The state of the buttons can be read using digital pins or a common analog output. DFRobot DFR0792
Touch keyboard module with 16 buttons based on the TTP229 chip. It is equipped with a connector with derived signals and a power supply diode
Touch keyboard module with 8 buttons based on the TTP226 chip. It is equipped with a connector with derived signals and LEDs that indicate the state of each button
Module with 5 colored buttons. Each button is powered independently and has an output informing about its status
Two-button module with 4 colored overlays. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020103
Module with a button and blue LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020046
Module with a button, LED diode and a blue cap. DFRobot DFR0029-B
The module is equipped with two buttons in red and blue. It communicates via a digital interface and allows you to add simple controls to your M5Stack based project. M5Stack U025
Module with a button and white LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-W